Reflection, refraction and the Fresnel equations
Electricity and magnetism · 83 questions and templates for CSIR NET Physics, in order from warm-up to top rank. Check each answer, then read the full solution.
Loading questions… (they need JavaScript; nothing you type is sent anywhere)
Written questions with solutions
The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.
-
MCQWarm-up
Light in air meets a non-magnetic dielectric of index at the Brewster angle . The angle of refraction isAnswer and solution
Answer: C
is the same as ; comparing with Snell's law gives . Then the angle between reflected and refracted rays is . The dipoles in medium 2 oscillate along the would-be reflected ray for p light, and a dipole does not radiate along its axis.Why people get this wrong: is the critical angle for light going the other way, a different thing.
-
MCQWarm-up
Total internal reflection at a plane boundary can occur only when light travels- from a medium of lower index to one of higher index
- from a medium of higher index to one of lower index
- at normal incidence
- in p polarisation only
Answer and solution
Answer: B
Snell: exceeds 1 for some angle only if . The critical angle is . Both polarisations are totally reflected beyond it.Why people get this wrong: TIR does not care about polarisation; Brewster does.
-
NATWarm-up
Light falls normally from air on still water (). The percentage of the intensity reflected is ______ (to two decimal places).Answer and solution
Answer: 2.01 % (±0.02)
, about 2.01%.Why people get this wrong: Forgetting to square the amplitude ratio gives 14%.
-
MCQWarm-up
Between two non-magnetic dielectrics, which Fresnel amplitude coefficient becomes zero at the Brewster angle?Answer and solution
Answer: D
At the p reflection coefficient vanishes, so only s light (E perpendicular to the plane of incidence) is reflected. The transmission coefficients never vanish (all the p light goes through), and is zero only for equal indices.Why people get this wrong: s comes from the German "senkrecht", perpendicular; it is the p wave that disappears from the reflection.
-
MCQWarm-up
At normal incidence from air onto glass, the reflected electric field relative to the incident field (same orientation convention)- is reversed in sign (phase change )
- has the same sign
- is shifted by
- has zero amplitude
Answer and solution
Answer: A
: the reflected is reversed. Going from glass to air it would keep its sign (). The magnetic field behaves the other way round.Why people get this wrong: The shift is for at reflection off the denser medium; for it is the rarer.
-
NATWarm-up
The critical angle for light going from flint glass () into air is ______ degrees (to one decimal place).Answer and solution
Answer: 38.7 ° (±0.1)
, so .Why people get this wrong: Using instead of gives the internal Brewster angle, .
-
MCQWarm-up
At night, a window of a brightly lit room looks like a mirror from inside, though in daytime you see straight through it. The best explanation is that- glass reflects more strongly when it is cold
- at night the glass reflects almost all the light that falls on it
- the glass reflects the same few per cent of light as by day, but the weak light coming in from the dark outside no longer swamps that reflection
- the room lights make the light polarised, and polarised light is reflected totally
Answer and solution
Answer: C
Each glass surface reflects about 4% at normal incidence whatever the time of day. In daytime the light coming in from outside is far brighter than the 8% of the room's light reflected back, so you see through. At night almost no light comes in, so the reflected image of the room dominates. From outside, the same window looks transparent: the lit room is bright compared with the reflection of the dark street.Why people get this wrong: The reflectance is a property of the surface; what changes is the light competing with the reflection.
-
NATStandard
A flint-glass prism () is immersed in benzene (). For light in the benzene striking the prism, the Brewster angle is ______ degrees (to one decimal place).Answer and solution
Answer: 47.2 ° (±0.1)
, so , close to because the indices are nearly matched (compare from air). When the indices match exactly the boundary vanishes and , though by then nothing is reflected at any angle.Why people get this wrong: The Brewster angle depends on the ratio of indices, not on alone.
-
MCQStandard
For oblique incidence from index into , the transmittance is rather than . The extra factor accounts for- absorption in the second medium
- the change in wave speed and the change in beam cross-section
- the phase shift on transmission
- the reflected beam
Answer and solution
Answer: B
Intensity in a medium is (factor ), and power through a patch of the interface is intensity times (factor ). With both, . alone can even exceed 1, for example from glass to air at normal incidence.Why people get this wrong: An amplitude coefficient above 1 does not break energy conservation.
-
MSQStandard
Beyond the critical angle at a glass-air boundary, which statements are true?- The reflectance is 1 for both polarisations
- An evanescent field exists in the air
- The time-averaged energy flow across the boundary is zero
- The s and p reflected waves have equal phase shifts
Answer and solution
Answer: A, B, C
With , is imaginary and . The transmitted field decays as while running along the surface; its normal Poynting component averages to zero. The phase shifts differ (that is how a Fresnel rhomb makes circular light).Why people get this wrong: An evanescent wave is not "no field": the field is there, but carries no average power across.
-
NATStandard
At normal incidence from air into glass (), the amplitude transmission coefficient is ______ (to two decimal places).Answer and solution
Answer: 0.8 (±0.005)
. Check: and , adding to 1.Why people get this wrong: (here ), not in general; for glass to air .
-
MCQStandard
At normal incidence, the reflectance of a glass-air surface for light inside the glass, compared with that for light coming from the air, is- larger, because the glass is denser
- smaller, because of the phase change
- zero
- the same
Answer and solution
Answer: D
is symmetric in and . Only the sign of changes (, a Stokes relation).Why people get this wrong: At oblique incidence the two sides differ (and only the inside can show TIR).
-
NATStandard
For a certain interface the amplitude reflection coefficient from side 1 is . Using the Stokes relations, the product of the transmission coefficients from side 1 and from side 2 is ______ (to two decimal places).Answer and solution
Answer: 0.91 (±0.005)
Time-reversing the reflected and transmitted waves must rebuild the incident one: and . So .Why people get this wrong: is not : the two transmission coefficients differ.
-
MCQStandard
For s polarisation (E perpendicular to the plane of incidence) between non-magnetic media, the amplitude reflection coefficient is- at every angle
Answer and solution
Answer: B
Continuity of tangential : . Continuity of tangential : . Eliminating : . The first option is (up to an overall sign) the p coefficient; the last is .Why people get this wrong: In each index pairs with the cosine of its own medium; in they are crossed.
-
MCQStandard
Light inside a glass block () meets the glass-air surface. The internal Brewster angle is closest toAnswer and solution
Answer: A
, so , the complement of the external value (the internal one is the refraction angle of the external one). It is below the critical angle , as it must be.Why people get this wrong: is the critical angle, not the Brewster angle.
-
MSQStandard
Which statements follow from requiring the boundary conditions to hold at every point of a plane interface and at every instant?- The reflected and transmitted waves have the same frequency as the incident wave
- The tangential component of is the same for all three waves (giving Snell's law)
- The amplitude ratios follow from continuity of tangential and
- The wavelength is the same on both sides
Answer and solution
Answer: A, B, C
The phases must match all along the interface for all : same , same tangential , so and . The amplitudes then come from the field conditions (the Fresnel equations). The wavelength changes.Why people get this wrong: Snell's law is purely kinematic; it holds for any kind of wave.
-
MCQStandard
A plane wave in vacuum falls normally on a lossless material with relative permittivity and relative permeability . There is no reflection when- only
Answer and solution
Answer: C
In impedance form with . Zero reflection needs , i.e. , even though the index differs from 1. This is the idea behind radar-absorbing ferrites.Why people get this wrong: Matching impedance, not refractive index, removes reflection.
-
NATStandard
An ideal single-layer antireflection coating for glass of index 1.52 in air, designed for 550 nm, has thickness ______ nm (to one decimal place).Answer and solution
Answer: 111.5 nm (±0.6)
The two reflections cancel when they have equal size () and opposite phase (optical thickness a quarter wave). So nm.Why people get this wrong: Use the wavelength inside the coating, , not 550 nm itself.
-
NATStandard
An uncoated germanium window ( in the infrared) is used in air. The percentage of the infrared intensity reflected at its front surface at normal incidence is ______ %.Answer and solution
Answer: 36 % (±0.1)
, that is 36%. With two surfaces, barely 40% of the light would get through an uncoated window, which is why infrared optics are always given anti-reflection coatings.Why people get this wrong: is the amplitude ratio; square it for intensity.
-
MCQStandard
Polarising sunglasses cut the glare reflected from a lake surface. To do this, their transmission axis must be- horizontal, because reflected glare is polarised vertically
- vertical, because reflected glare is mostly polarised with its electric field horizontal
- at 45° to the horizontal
- along the line of sight
Answer and solution
Answer: B
Light reflected from a horizontal surface is mostly s-polarised: its electric field is perpendicular to the (vertical) plane of incidence, i.e. horizontal. Near Brewster's angle (about for water) the reflection is almost purely s. Lenses that pass only vertical block most of it while passing half of the unpolarised light from elsewhere.Why people get this wrong: The plane of incidence is vertical; the reflected field is mostly perpendicular to it.
-
MCQStandard
Light in air falls normally on a material whose refractive index is made larger and larger (), approaching a perfect conductor. The amplitude reflection coefficient tends toAnswer and solution
Answer: A
. All the light is reflected, with the electric field flipped so that the total tangential field at the surface is zero, as it must be at a perfect conductor. The standing wave in front of a mirror therefore has a node of at the surface.Why people get this wrong: would make the field at the surface double, not zero.
-
NATExam level
A He-Ne beam ( nm) is totally reflected inside glass () at a glass-air face, at incidence. The depth in the air at which the evanescent field amplitude falls to is ______ nm (nearest nm).Answer and solution
Answer: 285 nm (±2)
Tangential is fixed, so in air and . Then nm. The intensity falls to in half that depth.Why people get this wrong: Field versus intensity depth differ by a factor 2.
-
NATExam level
Light polarised perpendicular to the plane of incidence (s) falls from air on glass () at . The reflectance is ______ (to three decimal places).Answer and solution
Answer: 0.177 (±0.002)
, , . , so .Why people get this wrong: Using the normal-incidence 4% at all angles: rises steadily with angle.
-
NATExam level
Light polarised in the plane of incidence (p) falls from air on glass () at . The reflectance , in percent, is ______ (to two decimal places).Answer and solution
Answer: 2.52 % (±0.03)
, . , so : already below the 4% of normal incidence, on its way to zero at .Why people get this wrong: Crossing the indices wrongly (the s form) gives 5.8%.
-
MCQExam level
For light going from air into glass (), how does the p reflectance vary as the angle of incidence goes from to ?- It rises steadily from 4% to 100%
- It stays at 4% and then jumps to 100% at the critical angle
- It falls from 4% to zero near , then rises to 100% at grazing incidence
- It is zero at normal incidence and 4% at grazing
Answer and solution
Answer: C
At both polarisations give 4%. falls to zero at and then climbs to 1 at grazing incidence. rises steadily from 4% to 100%. There is no critical angle going into the denser medium.Why people get this wrong: The steady rise is the s curve.
-
MSQExam level
Unpolarised light falls from air on glass at the Brewster angle. Which statements are true?- The reflected light is completely s-polarised
- The transmitted light is partially polarised
- The s reflectance is zero
Answer and solution
Answer: A, B, C
At : , so the reflected beam is pure s. The transmitted beam has all the p light and of the s light, so it is only partly polarised (a pile of plates improves it). gives . is not zero (about 15% for ).Why people get this wrong: s and p are easy to swap: at Brewster it is p that vanishes from the reflection.
-
NATExam level
Unpolarised light is reflected from glass () at incidence. The degree of polarisation of the reflected light is ______ (to two decimal places).Answer and solution
Answer: 0.75 (±0.01)
; , . , . , . So .Why people get this wrong: Past the Brewster angle changes sign, but is positive again.
-
MCQExam level
Under total internal reflection, the phase difference between the reflected s and p components- is constant at for all angles beyond critical
- is zero at the critical angle and at grazing incidence, with a maximum in between
- grows steadily from zero at critical to at grazing
- is always zero
Answer and solution
Answer: B
with . It vanishes at and at , with a maximum in between: about for glass.Why people get this wrong: Each component alone has a phase that grows from 0 to ; their difference does not.
-
NATExam level
Light is totally reflected inside glass () at a glass-air face at incidence. Using with , the phase difference between s and p is ______ degrees (to one decimal place).Answer and solution
Answer: 40.5 ° (±0.15)
, , . , so and .Why people get this wrong: Forgetting to double the half-angle.
-
MCQExam level
A metal has complex refractive index . Its normal-incidence reflectance from air isAnswer and solution
Answer: D
, so . A large drives towards 1, whatever is.Why people get this wrong: Ignoring makes silver () look like a good antireflection surface.