Home / Courses / GATE Physics / Practice / DC transients and AC circuits

DC transients and AC circuits

Electricity and magnetism · 15 questions and templates for GATE Physics, in order from warm-up to top rank. Check each answer, then read the full solution.

Loading questions… (they need JavaScript; nothing you type is sent anywhere)

Written questions with solutions

The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.

  1. MCQExam level

    A charged capacitor discharges through a series inductor and resistor. The charge returns to zero fastest without oscillating when
    1. R=L/C
    2. R=2L/C
    3. R=12L/C
    4. R=0
    Answer and solution

    Answer: B

    Lq¨+Rq˙+q/C=0 has roots s=−R2L±R24L2−1LC. Critical damping, where the square root vanishes, is R=2L/C. Less resistance oscillates; more creeps back slowly.

    Why people get this wrong: L/C without the 2 is the characteristic impedance, not the critical resistance.

  2. NATExam level

    For a series circuit with L=0.20 H and C=5.0μF, the resistance for critical damping is ______ Ω.
    Answer and solution

    Answer: 400 $\Omega$ (±1)

    Rc=2L/C=20.20/(5.0×10−6)=24×104=400 Ω.

    Why people get this wrong: Forgetting the factor 2 gives 200 Ω.

  3. MSQExam level

    Which statements about the free (undriven) series LCR circuit are correct?
    1. It oscillates if R<2L/C.
    2. When it oscillates, the angular frequency is 1LC−R24L2.
    3. When critically damped, the charge returns to zero fastest without overshooting.
    4. When overdamped, it oscillates with a decaying amplitude.
    Answer and solution

    Answer: A, B, C

    The characteristic roots are complex when R2/4L2<1/LC, i.e. R<2L/C, giving decaying oscillations at ωd=ω02−(R/2L)2. At equality the response is critical: quickest return without overshoot. Above it (overdamped) both roots are real and negative: no oscillation, just a slow decay.

    Why people get this wrong: Overdamped means too much damping to oscillate at all.

  4. MCQExam level

    An ideal inductor and an ideal capacitor are connected in parallel across an AC source at their resonant frequency 1/LC. The current drawn from the source is
    1. zero, because the impedance is infinite
    2. very large, because the impedance is zero
    3. the same as through the inductor alone
    4. twice the current through the capacitor
    Answer and solution

    Answer: A

    In parallel each branch gets the full source voltage. The inductor current lags by 90∘ and the capacitor current leads by 90∘; at resonance they are equal and cancel. The source supplies nothing while a large current circulates round the LC loop. Real coils have resistance, so the line current is small, not zero.

    Why people get this wrong: Series resonance gives minimum impedance; parallel resonance gives maximum.

  5. NATHard

    A capacitor charges from zero through a resistor from a battery. The time at which the stored energy reaches half of its final value, in units of the time constant τ, is ______ (to two decimal places).
    Answer and solution

    Answer: 1.23 $\tau$ (±0.01)

    U∝V2∝(1−e−t/τ)2. Setting this to 12: 1−e−t/τ=1/2, so e−t/τ=0.2929 and t=τln⁡(1/0.2929)=1.23τ.

    Why people get this wrong: Using τln⁡2=0.69τ, which is when the voltage reaches half.

  6. MSQHard

    A series LCR circuit with finite Q is driven by a source of fixed rms voltage and variable frequency. Which statements are correct?
    1. The current is largest at ω0=1/LC.
    2. The voltage across C is largest at a frequency a little below ω0.
    3. The voltage across L is largest at a frequency a little above ω0.
    4. The average power drawn is largest at a frequency below ω0.
    Answer and solution

    Answer: A, B, C

    I=V/|Z| and P=I2R both peak exactly at ω0. But VC=I/(ωC) has an extra 1/ω that favours lower frequencies, and VL=IωL an extra ω favouring higher ones; for large Q the shifts are tiny. This mirrors a driven oscillator, where displacement peaks below ω0 but velocity and power peak exactly at it.

    Why people get this wrong: Power follows the current, so it peaks exactly at ω0.

  7. NATHard

    A series circuit with L=1.0 H, C=1.0μF and R=200 Ω is left to oscillate freely. Its oscillation frequency is ______ Hz (to one decimal place).
    Answer and solution

    Answer: 158.4 Hz (±0.5)

    ω0=1/LC=1000 rad/s and γ=R/2L=100 s−1. ωd=ω02−γ2=106−104=995.0 rad/s, so fd=995.0/2π=158.4 Hz (just below f0=159.2 Hz).

    Why people get this wrong: Using R/L instead of R/2L for the damping rate.

  8. NATHard

    A series circuit has R=10 Ω, L=10 mH and C=1.0μF. The upper half-power angular frequency is ______ rad/s (to the nearest whole number).
    Answer and solution

    Answer: 10512 rad/s (±10)

    Half power where |XL−XC|=R: ωL−1ωC=R, a quadratic with positive root ω+=R2L+R24L2+1LC=500+2.5×105+108=500+10012.5=10512 rad/s. The lower one is 10012.5−500=9512 rad/s; their difference is R/L=1000 exactly, and their product is ω02.

    Why people get this wrong: Taking ω0+R/2L=10500: close, but the half-power points sit symmetric about ω0 only on a log scale.

  9. MCQHard

    A series LCR circuit is driven exactly at resonance in the steady state. The total energy stored in the inductor and capacitor together
    1. oscillates at twice the driving frequency
    2. is zero on average
    3. grows steadily with time
    4. is constant in time
    Answer and solution

    Answer: D

    With I=I0cos⁡ω0t, q=(I0/ω0)sin⁡ω0t. Then U=12LI02cos2⁡ω0t+I022Cω02sin2⁡ω0t, and since 1/(Cω02)=L, U=12LI02, constant. Energy just sloshes between L and C while the source feeds exactly what R burns. Off resonance the total stored energy does oscillate.

    Why people get this wrong: Each energy alone oscillates at 2ω; at resonance the two oscillations cancel exactly.

  10. NATHard

    A charged 1.0 μF capacitor discharges through a 10 mH inductor and a 100 Ω resistor in series. The frequency of the damped oscillation is ______ Hz (to the nearest whole number).
    Answer and solution

    Answer: 1378 Hz (±3)

    ωd=ω02−γ2 with ω02=1LC=108 s⁻² and γ=R2L=5000 s⁻¹. So ωd=108−2.5×107=8660 rad/s and f=86602π=1378 Hz, noticeably below the undamped 1592 Hz.

    Why people get this wrong: Using γ=R/L instead of R/2L.

  11. NATTop rank

    A 12 V battery, a 2.0 kΩ resistor and a 3.0μF capacitor are in series, and a 4.0 kΩ resistor is connected directly across the capacitor. The capacitor starts uncharged. Its voltage 4.0 ms after the switch closes is ______ V (to two decimal places).
    Answer and solution

    Answer: 5.06 V (±0.05)

    Replace the battery and the two resistors by their Thevenin equivalent as seen by the capacitor: Vth=12×42+4=8 V and Rth=2∥4=1.333 kΩ. So τ=RthC=4.0 ms and VC=8(1−e−t/τ). At t=4.0 ms: 8(1−e−1)=5.06 V.

    Why people get this wrong: Using the full 12 V and 2 kΩ (as if the 4 kΩ were absent), giving τ=6 ms and the wrong final voltage.

  12. MSQTop rank

    Which statements about the quality factor Q of a series LCR circuit are correct?
    1. Q=ω0/Δω, where Δω is the half-power bandwidth.
    2. Q=2π× (energy stored)/(energy lost per cycle) at resonance.
    3. Increasing R increases Q.
    4. At resonance the capacitor voltage is Q times the source voltage.
    Answer and solution

    Answer: A, B, D

    Δω=R/L, so ω0/Δω=ω0L/R=Q. Stored energy at resonance is 12LI02; loss per cycle is 12I02R×2π/ω0; the ratio times 2π is ω0L/R. VC=QV (shown in the lesson). Q=1RL/C falls as R rises.

    Why people get this wrong: For a parallel tank with the resistor in parallel, Q rises with R (it is RC/L). The question says series.

  13. MCQTop rank

    A coil (inductance L, resistance R) is connected in parallel with a capacitor C. The source current is in phase with the source voltage at the angular frequency
    1. 1LC+R2L2
    2. 1LC
    3. 1LC−R2L2
    4. 1LC−R24L2
    Answer and solution

    Answer: C

    Admittance Y=jωC+1R+jωL=jωC+R−jωLR2+ω2L2. Unity power factor needs the imaginary part zero: C=LR2+ω2L2, so ω2=1LC−R2L2.

    Why people get this wrong: The last option is the damped free-oscillation frequency of a series circuit, a different question.

  14. NATTop rank

    An AC source of 100 V rms has internal impedance (30+40j) Ω. The load impedance is chosen to draw the greatest possible average power. That power is ______ W (to one decimal place).
    Answer and solution

    Answer: 83.3 W (±0.4)

    Maximum transfer needs the load to be the complex conjugate of the source impedance, ZL=30−40j Ω: the reactances cancel, leaving 60 Ω in total. I=100/60=1.667 A and PL=I2(30)=83.3 W =V2/(4Rs).

    Why people get this wrong: Matching |ZL|=|Zs|=50 Ω with a pure resistor gives less: P=1002×50/((80)2+402)=62.5 W.

  15. MSQTop rank

    Which statements about Thevenin and Norton equivalents of a linear network are true?
    1. The Norton current equals the Thevenin voltage divided by the Thevenin resistance
    2. With only independent sources, Rth is found by replacing voltage sources with shorts and current sources with open circuits
    3. Dependent (controlled) sources are also switched off when finding Rth
    4. When the load is matched for maximum power, the network delivers that power at 50% efficiency (counting the Thevenin resistance)
    Answer and solution

    Answer: A, B, D

    Shorting the output of the Thevenin circuit gives IN=Vth/Rth. Independent sources are switched off as stated, but a dependent source depends on voltages or currents inside the network and must be left in place (find Rth with a test source instead). At RL=Rth the same current flows through equal resistances, so half the power is lost in Rth.

    Why people get this wrong: Switching off dependent sources too; they are part of the network's response.

← All topics · Timed mock test →