Geometrical optics: mirrors, lenses and systems
Oscillations, waves and optics · 78 questions and templates for IIT JAM Physics, in order from warm-up to top rank. Check each answer, then read the full solution.
New to this topic? Read the lesson first: Geometrical optics: mirrors, lenses and systems.
Loading questions… (they need JavaScript; nothing you type is sent anywhere)
Written questions with solutions
The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.
-
MCQWarm-up
The critical angle for light going from glass of refractive index into air is aboutAnswer and solution
Answer: B
, so . Beyond this angle of incidence, no light leaves the glass.Why people get this wrong: is the critical angle for water ().
-
NATWarm-up
A swimming pool is m deep and filled with water (). Looking straight down, the bottom appears to be ______ m below the surface.Answer and solution
Answer: 1.5 m (±0.01)
For near-normal viewing, apparent depth real depth m.Why people get this wrong: Multiplying by makes the pool look deeper; it looks shallower.
-
MCQWarm-up
An object is placed at a distance in front of a thin convex lens of focal length . The image is- virtual, upright and magnified
- at infinity
- real, inverted, the same size, at behind the lens
- real, inverted and twice the size
Answer and solution
Answer: C
with : , so . Magnification : real, inverted, same size. -
NATWarm-up
A convex lens has focal length cm. Its power is ______ dioptres.Answer and solution
Answer: 4 D
Power with in metres: D.Why people get this wrong: Using centimetres gives .
-
MCQWarm-up
A ray reflects from a plane mirror. Keeping the ray fixed, the mirror is turned through an angle . The reflected ray turns throughAnswer and solution
Answer: D
Turning the mirror by turns the normal by . The angle of incidence changes by and so does the angle of reflection, on the other side of the normal: the reflected ray turns by . This doubling is used in galvanometer mirrors. -
MCQWarm-up
Fermat's principle states that between two points light follows a path for which- the travel time is stationary (usually a minimum)
- the geometric distance is always the smallest
- the speed is greatest
- the number of reflections is the least
Answer and solution
Answer: A
The optical path (equivalently the travel time) is stationary: a minimum in most cases, sometimes a maximum or a saddle (for example reflection inside an ellipse). It is not the shortest distance: a refracted ray bends.Why people get this wrong: Shortest distance and least time agree only in a uniform medium.
-
NATStandard
An object stands cm in front of a convex lens of focal length cm. The image forms ______ cm behind the lens.Answer and solution
Answer: 60 cm (±0.1)
, so cm: real, behind the lens, magnification . -
NATStandard
An object is cm in front of a concave mirror of radius of curvature cm. The magnitude of the magnification is ______.Answer and solution
Answer: 3 (±0.01)
cm, cm. , so cm: a virtual image behind the mirror. Magnification : upright and three times larger (a shaving mirror).Why people get this wrong: Using cm instead of .
-
MCQStandard
A thin biconvex lens of glass () has both radii of curvature cm. In air its focal length is- cm
- cm
- cm
- cm
Answer and solution
Answer: B
, so cm ( cm for the second surface).Why people get this wrong: Taking both radii as cm makes the bracket zero.
-
NATStandard
A prism with apex angle has refractive index . Its angle of minimum deviation is ______ degrees.Answer and solution
Answer: 30 degrees (±0.1)
: , so and . At minimum deviation the ray passes through the prism symmetrically. -
MSQStandard
Which statements about total internal reflection are correct?- Light must travel from a medium of higher index towards one of lower index.
- The angle of incidence must exceed the critical angle.
- The critical angle of diamond () is larger than that of glass ().
- Optical fibres guide light by total internal reflection.
Answer and solution
Answer: A, B, D
exists only if . For diamond , , smaller than glass (); that small angle traps light and makes diamonds sparkle. Fibres keep light inside a core of higher index than its cladding. -
MCQStandard
A thin convex lens of focal length cm is placed in contact with a thin concave lens of focal length cm. The combination behaves as- a converging lens of focal length cm
- a diverging lens of focal length cm
- a converging lens of focal length cm
- a diverging lens of focal length cm
Answer and solution
Answer: C
Powers add: , so cm, converging (the stronger lens wins).Why people get this wrong: Adding the focal lengths, or using with both positive ( cm).
-
MCQStandard
A glass lens () has a focal length of cm in air. When it is put in water (), its focal length becomes- cm
- cm
- cm
- cm
Answer and solution
Answer: C
The lensmaker's formula uses the relative index: . In air: . In water: . So grows by : cm, still converging (glass is still denser than water).Why people get this wrong: Using instead of the ratio gives cm.
-
NATStandard
The end of a long glass rod () is ground into a convex hemisphere of radius cm. An object in air is cm in front of this surface on the axis. The image forms inside the rod ______ cm from the surface.Answer and solution
Answer: 90 cm (±0.1)
with , , cm, cm: , so and cm.Why people get this wrong: Using the thin-lens formula: this is one surface, and the image is in glass, so multiplies .
-
MSQStandard
For real objects, which statements are correct?- A real image can be caught on a screen.
- A convex mirror always forms a virtual, upright, smaller image.
- A concave lens can form a real image.
- A concave mirror can form a virtual, magnified image.
Answer and solution
Answer: A, B, D
Real images are where light actually converges, so a screen shows them. Diverging elements (convex mirror, concave lens) always give virtual, upright, diminished images of real objects; a concave lens cannot form a real image of a real object. A concave mirror with the object inside its focus gives a virtual magnified image. -
NATStandard
A magnifying glass of focal length cm is used with the final image at the near point ( cm). Its angular magnification is ______.Answer and solution
Answer: 6
With the image at the near point, . With the image at infinity (relaxed eye) it would be .Why people get this wrong: Mixing the two cases: is for the image at infinity.
-
NATStandard
A girl walks towards a plane mirror at m/s (relative to the ground) while the mirror is pushed towards her at m/s. Her image approaches her at ______ m/s.Answer and solution
Answer: 8 m/s
Put the girl at and the mirror at . Her image sits as far behind the mirror as she is in front: . With the girl moving at m/s and the mirror at m/s, m/s. The image therefore approaches her at m/s, which is twice the rate at which she and the mirror close in ( m/s).Why people get this wrong: Adding the two speeds (4 m/s) gives how fast she nears the mirror, not her image; the image gap is twice the mirror gap.
-
MSQStandard
A man m tall, whose eyes are cm below the top of his head, wants to see his full height in a vertical plane mirror on a wall. Which statements are true?- The shortest mirror that works is m long
- Its top edge must be m above the floor
- Its bottom edge must be m above the floor
- If he steps back from the wall he needs a longer mirror
Answer and solution
Answer: A, B
Light from the top of his head reaches his eye after reflecting at the point halfway (in height) between head and eye: m. Light from his feet reflects halfway between feet and eye: m. So the mirror must run from m to m, a length m, half his height. These heights come from similar triangles and do not depend on how far he stands from the wall.Why people get this wrong: Placing the bottom edge at half his height (0.90 m); it is half the eye height, 0.85 m.
-
MCQStandard
A concave mirror has focal length cm in air. It is lowered into a tank of water (). Its focal length in water is- cm
- cm
- cm
- cm
Answer and solution
Answer: B
A mirror works by reflection only, and the law of reflection (angle in = angle out) does not involve the refractive index. So is set by the shape alone and stays cm. Only lenses (and refracting surfaces) change their focal length in a new medium.Why people get this wrong: Applying the lens-in-liquid rule to a mirror.
-
MCQStandard
Which of the following is NOT true of the image of a real object in a convex mirror?- It is real when the object is beyond the centre of curvature
- It is erect
- It lies behind the mirror, between the pole and the focus
- It is smaller than the object
Answer and solution
Answer: A
A convex mirror spreads light out. With and , (Cartesian), is always positive and less than : the image is virtual, behind the mirror, inside the focal length, erect and diminished, wherever the object is.Why people get this wrong: Carrying the concave-mirror rule "beyond C gives a real image" over to a convex mirror.
-
NATExam level
Two thin convex lenses, each of focal length cm, are placed cm apart on a common axis. The equivalent focal length is ______ cm (to two decimal places).Answer and solution
Answer: 13.33 cm (±0.05)
, so cm (measured from the principal planes, not from either lens).Why people get this wrong: Forgetting the term gives 10 cm (lenses in contact).
-
MCQExam level
An astronomical telescope has an objective of focal length cm and an eyepiece of cm, in normal adjustment (final image at infinity). Its angular magnification and length are- and cm
- and cm
- and cm
- and cm
Answer and solution
Answer: A
In normal adjustment the objective's image sits at the eyepiece's focus: length cm and (the image is inverted).Why people get this wrong: is the length of a Galilean telescope, which uses a concave eyepiece.
-
NATExam level
A compound microscope has an objective of focal length cm and an eyepiece of cm, cm apart. The final image is at infinity and the near point is cm. The magnitude of its magnifying power is ______.Answer and solution
Answer: 70 (±0.5)
The objective's image must sit at the eyepiece focus: cm. Then , cm, and . The eyepiece adds . Total .Why people get this wrong: Using the tube length 20 cm as ignores where the eyepiece needs the image.
-
MCQExam level
A mark on paper is viewed straight down through a glass slab cm thick () lying on it. The mark appears- raised by cm
- raised by cm
- lowered by cm
- raised by cm
Answer and solution
Answer: A
The slab makes the mark seem to be at depth cm below the top surface instead of cm: it is raised by cm. The shift does not depend on where the eye is (for near-normal viewing).Why people get this wrong: cm is the apparent depth below the top, not the shift.
-
NATExam level
An achromatic doublet of focal length cm is made from a crown-glass lens (dispersive power ) in contact with a flint-glass lens (dispersive power ). The focal length of the crown lens is ______ cm.Answer and solution
Answer: 20 cm (±0.1)
No colour error: , so . Combined power: , so cm (converging crown) and cm (diverging flint).Why people get this wrong: Making the more dispersive lens the converging one gives a diverging doublet.
-
MSQExam level
An object and a screen are a fixed distance apart. A convex lens of focal length between them gives a sharp image at two positions, a distance apart, with image heights and . Which statements are correct?- Two positions exist only if .
- .
- The object height is .
- The two magnifications are equal.
Answer and solution
Answer: A, B, C
With , the lens equation gives a quadratic with real, distinct roots only if . The two positions swap and , so and , giving . The magnifications are and , so .Why people get this wrong: The magnifications are reciprocal, not equal: one image is enlarged, the other reduced.
-
NATExam level
An object and a screen are cm apart. A convex lens gives sharp images at two positions cm apart. Its focal length is ______ cm.Answer and solution
Answer: 16 cm (±0.05)
cm. Check: the lens positions are cm and cm from the object, and . -
MCQExam level
A ray in water () meets a flat glass surface () at incidence. The angle of refraction in the glass is aboutAnswer and solution
Answer: C
Snell: , so and . Going into the denser medium the ray bends towards the normal.Why people get this wrong: Using air as the first medium (, ).
-
NATExam level
A prism gives a minimum deviation of . Its refractive index is ______ (to three decimal places).Answer and solution
Answer: 1.532 (±0.003)
. -
MCQExam level
An object is placed between the focus and the centre of curvature of a concave mirror. The image is- virtual, upright and magnified
- real, inverted and smaller, between and
- at infinity
- real, inverted and magnified, beyond
Answer and solution
Answer: D
With , the mirror equation gives : the image is real, inverted, beyond and larger than the object. (Object beyond gives the reverse: image between and , smaller.)