Solutions and colligative properties
Class 12 · 181 questions and templates for Medical entrance (NEET), in order from warm-up to top rank. Check each answer, then read the full solution.
New to this topic? Read the lesson first: Solutions and colligative properties.
Loading questions… (they need JavaScript; nothing you type is sent anywhere)
Written questions with solutions
The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.
-
MCQWarm-up
Which of these concentration terms does NOT change when the temperature of the solution changes?- Molality
- Molarity
- Normality
- Volume of solute per 100 mL of solution
Answer and solution
Answer: A
Molality is moles of solute per kg of solvent. Mass does not change with temperature. Molarity, normality and volume-based terms use the volume of the solution, and volume expands or shrinks when it is heated or cooled.
-
MCQWarm-up
A mixture has 2 mol of A and 3 mol of B. The mole fraction of A is- 0.6
- 0.4
- 0.67
- 0.5
Answer and solution
Answer: B
xA = nA/(nA + nB) = 2/(2 + 3) = 0.4. (0.6 is xB; 0.67 is the mole ratio 2/3, not the fraction.)
Why people get this wrong: Mole fraction divides by the total moles, not by the other component.
-
MCQWarm-up
Henry's law says that, at a fixed temperature, the- solubility of a gas in a liquid is independent of pressure
- total vapour pressure of a liquid mixture is the sum of the pure vapour pressures
- partial pressure of a gas above a solution is proportional to its mole fraction in the solution
- mole fraction of a gas in solution is inversely proportional to its partial pressure
Answer and solution
Answer: C
Henry's law: p = KH x. A gas dissolves more when its partial pressure above the liquid is higher. The statement about adding pure vapour pressures is a wrong form of Raoult's law (it needs the mole fractions).
-
MCQWarm-up
For a solution of a non-volatile solute, Raoult's law states that the vapour pressure of the solvent over the solution is- equal to the mole fraction of the solute times the vapour pressure of the pure solvent
- equal to the vapour pressure of the pure solvent plus the mole fraction of the solute
- independent of the amount of solute
- equal to the mole fraction of the solvent times the vapour pressure of the pure solvent
Answer and solution
Answer: D
p1 = x1 p1°. Adding solute lowers x1 below 1, so the vapour pressure falls. Multiplying by the solute mole fraction would give the amount of the lowering, not the vapour pressure.
-
MCQWarm-up
Colligative properties depend on- the number of solute particles, not their nature
- the nature of the solute only
- the molar mass of the solute only
- the colour and size of the solute particles
Answer and solution
Answer: A
Relative lowering of vapour pressure, elevation of boiling point, depression of freezing point and osmotic pressure all depend only on how many solute particles are present in a given amount of solvent.
-
MCQWarm-up
The SI-friendly unit of molality is- mol L-1
- mol kg-1
- mol per 100 g of solution
- g L-1
Answer and solution
Answer: B
Molality m = moles of solute / mass of solvent in kg. mol L-1 is molarity.
-
MCQWarm-up
A 2 litre solution contains 0.4 mol of solute. Its molarity is- 0.8 M
- 2 M
- 0.2 M
- 0.02 M
Answer and solution
Answer: C
M = moles/volume in litres = 0.4/2 = 0.2 M.
-
MCQWarm-up
Which pair of liquids forms a solution showing a negative deviation from Raoult's law?- Ethanol and acetone
- Carbon disulphide and acetone
- Benzene and methanol
- Acetone and chloroform
Answer and solution
Answer: D
Chloroform's H atom hydrogen-bonds to the oxygen of acetone, so A-B attraction is stronger than A-A and B-B: the vapour pressure is lower than ideal (negative deviation). The other pairs break existing hydrogen bonds or interactions and show positive deviation.
-
MCQWarm-up
A semipermeable membrane lets through- solvent molecules only
- solute molecules only
- both solvent and solute molecules
- neither of them
Answer and solution
Answer: A
Osmosis is the net flow of solvent through a semipermeable membrane from the dilute side (or pure solvent) to the more concentrated solution. The membrane blocks the solute.
-
MCQWarm-up
Reverse osmosis is used to obtain pure water from sea water. It works by applying- a pressure equal to atmospheric pressure on the pure-water side
- a pressure larger than the osmotic pressure on the sea-water side
- heat to evaporate the salt
- a pressure smaller than the osmotic pressure on the sea-water side
Answer and solution
Answer: B
If the external pressure on the solution is greater than its osmotic pressure, solvent flows from the solution through the membrane into the pure-solvent side, the reverse of normal osmosis.
-
MCQWarm-up
The van't Hoff factor i for a non-electrolyte such as glucose (no association) in water is- 0
- 2
- 1
- 0.5
Answer and solution
Answer: C
Glucose does not break up or join up in water, so the number of particles equals the number of formula units: i = 1.
-
MCQWarm-up
If 10 g of NaCl is dissolved in 90 g of water, the mass percent of NaCl in the solution is- 11.1 %
- 9 %
- 1 %
- 10 %
Answer and solution
Answer: D
Mass % = 10/(10 + 90) × 100 = 10 %. 11.1 % is the wrong denominator (solvent only).
Why people get this wrong: Divide by mass of the solution, not by the solvent.
-
MCQWarm-up
The unit of the cryoscopic constant Kf is- K kg mol-1
- K mol kg-1
- mol kg-1
- K-1 mol
Answer and solution
Answer: A
ΔTf = Kf m, so Kf = ΔTf/m has the unit K per (mol kg-1) = K kg mol-1.
-
MCQWarm-up
An ideal solution is one in which- ΔmixH is large and positive
- A-B interactions are equal to A-A and B-B interactions, so ΔmixH = 0 and ΔmixV = 0
- the solute does not dissolve at all
- the vapour pressure is always zero
Answer and solution
Answer: B
In an ideal solution molecules of A and B feel the same forces as they do among themselves, so mixing releases or absorbs no heat and the volumes simply add. It obeys Raoult's law over the whole range of composition.
-
MCQWarm-up
Adding a non-volatile solute to a liquid solvent- lowers the boiling point
- raises the freezing point
- raises the boiling point
- leaves both boiling and freezing points unchanged
Answer and solution
Answer: C
The solute lowers the vapour pressure. The solution must be heated to a higher temperature before its vapour pressure equals the atmospheric pressure, so it boils higher. The freezing point goes down.
-
MCQWarm-up
Soft drinks are packed under high pressure of CO2. This is an application of- Raoult's law
- Dalton's law of partial pressures
- Le Chatelier's principle for solids
- Henry's law
Answer and solution
Answer: D
A higher CO2 partial pressure above the liquid increases the amount of dissolved gas (Henry's law). When the bottle is opened the pressure falls and the gas fizzes out.
-
MCQWarm-up
Scuba divers breathe helium-diluted air instead of ordinary air at great depths. The reason is that- helium is much less soluble in blood than nitrogen at high pressure
- helium is lighter than nitrogen
- helium reacts with the blood
- nitrogen is poisonous even at low depth
Answer and solution
Answer: A
At depth the pressure is high, so more N2 dissolves in blood. On quick ascent it bubbles out and causes the bends. Helium dissolves far less, so fewer bubbles form.
-
MCQWarm-up
Two solutions are called isotonic when they- have the same boiling point and different freezing points
- have the same osmotic pressure at the same temperature
- contain the same mass of solute
- have the same density
Answer and solution
Answer: B
Isotonic = same osmotic pressure. No net osmosis occurs between isotonic solutions separated by a semipermeable membrane.
-
MCQWarm-up
Which one of the following is NOT a colligative property?- Osmotic pressure
- Elevation of boiling point
- Viscosity
- Relative lowering of vapour pressure
Answer and solution
Answer: C
Viscosity depends on the nature of the substances and their interactions, not only on particle count. The other three are colligative.
-
MCQWarm-up
In an aqueous solution of 1 mol of glucose in 9 mol of water, the mole fraction of glucose is- 0.9
- 0.11
- 0.01
- 0.1
Answer and solution
Answer: D
x = 1/(1 + 9) = 0.1. 0.11 is 1/9, the ratio of moles of solute to moles of solvent.
-
MCQWarm-up
A water sample has 5 mg of a pollutant in 1 kg of the sample. Its concentration in ppm (by mass) is- 5
- 0.5
- 50
- 0.005
Answer and solution
Answer: A
ppm = mass of solute / mass of solution × 106 = 5 × 10-3 g/1000 g × 106 = 5 ppm (1 mg per kg = 1 ppm).
-
NATStandard
Find the molarity of a solution made by dissolving 18 g of glucose (M = 180 g mol-1) in water to make 500 mL of solution.Answer and solution
Answer: 0.2 M (±0.005)
Moles = 18/180 = 0.1 mol. Volume = 0.5 L.
M = 0.1/0.5 = 0.2 M.
Why people get this wrong: Use the volume of solution in litres, not the mass of water.
-
NATStandard
Calculate the molality of a solution containing 4 g of NaOH (40 g mol-1) in 250 g of water.Answer and solution
Answer: 0.4 mol kg<sup>-1</sup> (±0.01)
Moles NaOH = 4/40 = 0.1. Solvent = 250 g = 0.25 kg.
m = 0.1/0.25 = 0.4 mol kg-1.
Why people get this wrong: Convert grams of solvent to kg.
-
MCQStandard
A solution is made from 36 g of water and 46 g of ethanol. The mole fraction of water in it is (H2O = 18, C2H5OH = 46)- 0.333
- 0.667
- 0.5
- 0.8
Answer and solution
Answer: B
Water: 36/18 = 2 mol. Ethanol: 46/46 = 1 mol.
xwater = 2/(2 + 1) = 0.667. (0.333 is the ethanol fraction.)
-
NATStandard
A pure solvent has vapour pressure 100 torr. A solution of 0.5 mol of a non-volatile solute in 4.5 mol of this solvent is prepared. Find the vapour pressure of the solution.Answer and solution
Answer: 90 torr (±0.5)
Mole fraction of solvent = 4.5/(4.5 + 0.5) = 0.9.
p = x1p° = 0.9 × 100 = 90 torr.
-
NATStandard
A gas has KH = 40 kbar (40 000 bar) in water at a certain temperature. What is its mole fraction in water when its partial pressure is 2 bar? Give the answer in units of 10-5.Answer and solution
Answer: 5 × 10<sup>-5</sup> (±0.05)
p = KH x, so x = p/KH = 2/40 000 = 5 × 10-5.
Why people get this wrong: Convert kbar to bar before dividing.
-
NATStandard
The boiling point of water rises by how many kelvin when 3 g of urea (60 g mol-1) is dissolved in 100 g of water? Kb = 0.52 K kg mol-1.Answer and solution
Answer: 0.26 K (±0.01)
Moles urea = 3/60 = 0.05; m = 0.05/0.1 kg = 0.5 mol kg-1.
ΔTb = Kbm = 0.52 × 0.5 = 0.26 K.
-
NATStandard
By how much does the freezing point of 1 kg of water fall when 18 g of glucose (180 g mol-1) is dissolved? Kf = 1.86 K kg mol-1.Answer and solution
Answer: 0.186 K (±0.003)
m = (18/180)/1 = 0.1 mol kg-1.
ΔTf = 1.86 × 0.1 = 0.186 K.
-
NATStandard
Find the osmotic pressure of a 0.1 M glucose solution at 300 K. R = 0.082 L atm K-1 mol-1.Answer and solution
Answer: 2.46 atm (±0.02)
π = CRT = 0.1 × 0.082 × 300 = 2.46 atm.
Why people get this wrong: Glucose does not ionise, so i = 1.
-
MCQStandard
Concentrated sulphuric acid is 98 % H2SO4 by mass and has density 1.84 g mL-1. Its molarity is (H2SO4 = 98)- 1.84 M
- 9.2 M
- 18.4 M
- 184 M
Answer and solution
Answer: C
1 L has mass 1840 g. H2SO4 mass = 0.98 × 1840 = 1803.2 g, which is 1803.2/98 = 18.4 mol.
Molarity = 18.4 M. Shortcut: M = (% × 10 × d)/M0 = 98 × 10 × 1.84/98.