Home / Courses / Engineering entrance / Practice / Electric potential and capacitors

Electric potential and capacitors

Class 12 · 250 questions and templates for Engineering entrance, in order from warm-up to top rank. Check each answer, then read the full solution.

New to this topic? Read the lesson first: Electric potential and capacitors.

Loading questions… (they need JavaScript; nothing you type is sent anywhere)

Written questions with solutions

The same questions as a list, so you can print them or read without the practice box. Templates (fresh numbers) appear only in the practice box above.

  1. MCQWarm-up

    The SI unit of electric potential, the volt, is the same as
    1. NC−1
    2. JC−1
    3. JC
    4. CJ−1
    Answer and solution

    Answer: B

    Potential is work per unit charge, V=W/q, so 1 V = 1 J/C. N/C is the unit of electric field (it equals V/m).
  2. MCQWarm-up

    The electric potential at a distance r from a negative point charge −q (zero at infinity) is
    1. negative, equal to −q4πε0r
    2. positive, equal to +q4πε0r
    3. zero, because the charge is negative
    4. negative, equal to −q4πε0r2
    Answer and solution

    Answer: A

    Potential is a scalar and carries the sign of the source charge: V=14πε0(−q)r. It falls as 1/r, not 1/r2 (that is the field).
  3. NATWarm-up

    Find the potential at 0.3 m from a point charge of 3 nC (in volts). 14πε0=9×109 SI.
    Answer and solution

    Answer: 90 V (±0.5)

    V=kqr=9×109×3×10−90.3=90 V.
  4. MCQWarm-up

    Inside a charged conductor in electrostatic equilibrium the potential is
    1. zero
    2. highest at the centre
    3. decreasing steadily from the surface to the centre
    4. the same everywhere and equal to its surface value
    Answer and solution

    Answer: D

    The field inside is zero, so V does not change from point to point: the whole conductor is an equipotential. It is not zero in general (a charged sphere at 900 V has 900 V inside too).

    Why people get this wrong: Zero field does not mean zero potential.

  5. MCQWarm-up

    The electric field at any point of an equipotential surface is
    1. parallel to the surface
    2. zero everywhere on it
    3. perpendicular to the surface
    4. at 45∘ to the surface
    Answer and solution

    Answer: C

    If the field had a component along the surface, a charge would gain energy when moved along it, so the potential would change. Hence the field is normal to the surface. (It need not be zero: the surface of a point charge's equipotential has non-zero field.)
  6. MCQWarm-up

    The capacitance of a parallel plate capacitor does NOT depend on
    1. the area of the plates
    2. the charge on the plates
    3. the gap between the plates
    4. the medium between the plates
    Answer and solution

    Answer: B

    C=Kε0A/d depends only on geometry and the medium. Q=CV changes with the voltage, but C stays the same.
  7. NATWarm-up

    A 2 μF capacitor is connected to a 12 V battery. How much charge does it store (in μC)?
    Answer and solution

    Answer: 24 µC (±0.1)

    Q=CV=2 μF×12 V=24 μC.
  8. MCQWarm-up

    The gap between the plates of an isolated parallel plate capacitor is doubled (same plates and medium). Its capacitance becomes
    1. half
    2. double
    3. one-fourth
    4. unchanged
    Answer and solution

    Answer: A

    C=ε0A/d, so C∝1/d. Doubling d halves C.
  9. MCQWarm-up

    Capacitors C1 and C2 are joined in series. The equivalent capacitance is
    1. equal to C1+C2
    2. larger than the larger of the two
    3. always the average of the two
    4. smaller than the smaller of the two
    Answer and solution

    Answer: D

    1C=1C1+1C2, so 1C is bigger than either 1C1 or 1C2 and C is smaller than both. Parallel is the one that adds.
  10. NATWarm-up

    Capacitors of 3 μF, 5 μF and 7 μF are connected in parallel. Find the equivalent capacitance (in μF).
    Answer and solution

    Answer: 15 µF

    In parallel the capacitances add: 3+5+7=15 μF.
  11. NATWarm-up

    A 10 μF capacitor is charged to 20 V. Find the energy stored (in mJ).
    Answer and solution

    Answer: 2 mJ (±0.01)

    U=12CV2=12×10×10−6×202=2×10−3 J =2 mJ.
  12. MCQWarm-up

    When a dielectric of constant K completely fills the space between the plates of a capacitor, the capacitance becomes
    1. 1/K of the original
    2. K2 times the original
    3. K times the original
    4. unchanged
    Answer and solution

    Answer: C

    Polarised molecules of the dielectric reduce the field inside, so the same charge needs a smaller voltage: C=KC0, with K>1.
  13. MCQWarm-up

    The work done in moving a charge between two points on the same equipotential surface is
    1. positive
    2. zero
    3. negative
    4. dependent on the path
    Answer and solution

    Answer: B

    W=q(VA−VB) and VA=VB, so W=0 along any path between the two points.
  14. MCQWarm-up

    One electron volt (eV) is equal to
    1. 1.6×10−19 J
    2. 1.6×1019 J
    3. 9.1×10−31 J
    4. 1.6×10−19 V
    Answer and solution

    Answer: A

    It is the energy gained by one electron (1.6×10−19 C) in falling through 1 volt: 1.6×10−19×1=1.6×10−19 J. It is a unit of energy, not of potential.
  15. MCQWarm-up

    The electric potential at any point on the perpendicular bisector (equatorial line) of an electric dipole is
    1. maximum
    2. proportional to 1/r2
    3. negative
    4. zero
    Answer and solution

    Answer: D

    Every point on the bisector is equally far from +q and −q, so the two potentials ±kqr cancel. The field there is not zero.

    Why people get this wrong: The potential vanishes on the bisector, but the field does not.

  16. MCQWarm-up

    The relation between the electric field and the potential along x is
    1. Ex=+dVdx
    2. Ex=Vx
    3. Ex=−dVdx
    4. Ex=−∫Vdx
    Answer and solution

    Answer: C

    The field points in the direction of fastest fall of potential, so Ex=−dV/dx. Its unit is V/m, the same as N/C.
  17. NATWarm-up

    An alpha particle (charge +2e) is accelerated from rest through a potential difference of 500 V. Find its kinetic energy gained (in eV).
    Answer and solution

    Answer: 1000 eV

    Energy =qV=2e×500 V=1000 eV. Using eV directly avoids the 1.6×10−19 factor.
  18. NATStandard

    Charges +2 μC and −4 μC are 0.6 m apart in air. Find the potential at the midpoint of the line joining them (in kV). 14πε0=9×109 SI.
    Answer and solution

    Answer: -60 kV (±0.5)

    Each charge is 0.3 m from the midpoint. Add the potentials as scalars, with signs: V=k(2×10−60.3+−4×10−60.3)=9×109×−2×10−60.3=−6×104 V =−60 kV.

    Why people get this wrong: Potentials add as numbers, with signs; fields add as vectors.

  19. NATStandard

    Four equal charges of 5 nC sit at the corners of a square of side 0.2 m. Find the potential at the centre of the square (in V). 14πε0=9×109 SI.
    Answer and solution

    Answer: 1273 V (±2)

    Each corner is at r=0.22=0.1414 m from the centre. V=4kqr=4×9×109×5×10−90.1414=1273 V. (The field at the centre is zero, the potential is not.)
  20. NATStandard

    A charge of 2 μC is moved from a point A at 80 V to a point B at −20 V. Find the work done BY the electric field (in μJ).
    Answer and solution

    Answer: 200 µJ (±0.5)

    Wfield=q(VA−VB)=2 μC×(80+20) V=200 μJ. The charge goes from high to low potential, so a positive charge is helped by the field.
  21. NATStandard

    An electron starts from rest and is accelerated through 200 V. Find its final speed (in units of 106 ms−1, 2 decimals; e=1.6×10−19 C, m=9.1×10−31 kg).
    Answer and solution

    Answer: 8.39 ×10⁶ m/s (±0.02)

    12mv2=eV, so v=2eVm=2×1.6×10−19×2009.1×10−31=8.39×106 ms−1.
  22. NATStandard

    Point charges of 3 μC and 5 μC are 0.9 m apart. Find the electric potential energy of the pair (in J). 14πε0=9×109 SI.
    Answer and solution

    Answer: 0.15 J (±0.002)

    U=kq1q2r=9×109×3×10−6×5×10−60.9=0.15 J.
  23. NATStandard

    Three identical charges of 2 μC are placed at the corners of an equilateral triangle of side 0.3 m. Find the electric potential energy of the system (in J).
    Answer and solution

    Answer: 0.36 J (±0.002)

    There are 3 pairs, each at 0.3 m: U=3kq2a=3×9×109×(2×10−6)20.3=0.36 J.
  24. NATStandard

    A thin ring of radius 0.3 m carries a uniform charge of 8 μC. Find the potential at a point on its axis 0.4 m from the centre (in kV).
    Answer and solution

    Answer: 144 kV (±0.5)

    Every bit of charge is at the same distance R2+x2=0.09+0.16=0.5 m, so V=kQR2+x2=9×109×8×10−60.5=1.44×105 V =144 kV.
  25. NATStandard

    A thin conducting shell of radius 0.2 m carries 4 μC. Find the potential at a point 0.1 m from its centre (in kV).
    Answer and solution

    Answer: 180 kV (±0.5)

    Inside a shell the potential is constant and equals its surface value: V=kQR=9×109×4×10−60.2=1.8×105 V =180 kV. Using r=0.1 m would give 360 kV: wrong.

    Why people get this wrong: Inside, V is constant, not kQ/r.

  26. NATStandard

    A parallel plate capacitor has plates of area 200 cm2 separated by 2 mm of air. Find its capacitance (in pF). Take 14πε0=9×109 Nm2C−2 and ε0=8.85×10−12 Fm−1.
    Answer and solution

    Answer: 88.5 pF (±0.2)

    C=ε0Ad=8.85×10−12×0.020.002=8.85×10−11 F =88.5 pF. (Change cm2 to m2: 200 cm2=0.02 m2.)

    Why people get this wrong: Convert cm² to m² and mm to m.

  27. NATStandard

    A 3 μF and a 6 μF capacitor are connected in series across a 12 V battery. Find the potential difference across the 3 μF capacitor (in V).
    Answer and solution

    Answer: 8 V (±0.1)

    Ceq=3×69=2 μF, so Q=2×12=24 μC on each. V3=Q/3=8 V (and V6=4 V). The smaller capacitor takes the larger share of the voltage.
  28. NATStandard

    Find the capacitance of an isolated conducting sphere of radius 0.9 m (in pF). 14πε0=9×109 SI.
    Answer and solution

    Answer: 100 pF (±0.5)

    C=4πε0R=Rk=0.99×109=1×10−10 F =100 pF.
  29. NATStandard

    The electric field in a region of air is 3×105 Vm−1. Find the energy stored per unit volume (in Jm−3, 2 decimals; ε0=8.85×10−12).
    Answer and solution

    Answer: 0.4 J/m³ (±0.01)

    u=12ε0E2=12×8.85×10−12×(3×105)2=0.398 Jm−3≈0.40.
  30. NATStandard

    A dipole has charges ±2 nC separated by 1 cm. Find the potential at a point on its axis 10 cm from its centre, on the side of the positive charge (in V; use the small-dipole formula, 14πε0=9×109 SI).
    Answer and solution

    Answer: 18 V (±0.5)

    p=2×10−9×0.01=2×10−11 C m. On the axis V=kpr2=9×109×2×10−11(0.1)2=18 V.

← All topics