Module 9: Condensed matter physics · Lesson 9.3 · about 45 min
Dielectric and optical properties of solids
How solids respond to electric fields from DC to ultraviolet: electronic, ionic and orientational polarisability, the Lorentz local field and the Clausius-Mossotti relation, the Langevin-Debye law, Debye relaxation and dielectric loss, the Lorentz oscillator and the Lyddane-Sachs-Teller relation, the Drude metal with its plasma frequency, reflectivity and skin depth, and the Kramers-Kronig link between ε′ and ε″.
Module 9 · about 45 minutes. The JAM lesson on dielectrics and the GATE lesson on fields in matter treated as a number. Here it becomes a complex function of frequency, , built from the motion of the charges inside. One function explains why glass is transparent, why metals shine, why water heats in a microwave oven and why sodium lets ultraviolet through.
1. Polarisability and the local field
An atom in a field gets a dipole . Three mechanisms add:
- Electronic `$\alpha_e$`
- the electron cloud shifts against its nucleus; follows the field into the ultraviolet (resonance near 10¹⁶ rad/s). For an atom of radius `$R$`, a uniform-cloud model gives `$\alpha_e = 4\pi\varepsilon_0R^3$`
- Ionic `$\alpha_i$`
- positive and negative ions shift oppositely; follows up to the infrared (transverse optical phonon, 10¹³ rad/s)
- Orientational `$p_0^2/3k_BT$`
- permanent dipoles turn towards the field against thermal agitation (Langevin-Debye); drops out in the microwave, where rotation cannot keep up
In a dense solid the field at an atom is not the average field . Cut out a small sphere around the atom: the polarised material outside leaves a surface charge on the sphere that adds (for cubic symmetry the dipoles inside the sphere cancel). This is the Lorentz local field.
Local field. Eloc = E + P/3ε₀.
Polarisation. P = Nα Eloc = Nα(E + P/3ε₀), so P = NαE/(1 − Nα/3ε₀).
Permittivity. εr = 1 + P/ε₀E. Writing x = Nα/3ε₀ gives εr = (1 + 2x)/(1 − x), which rearranges to Clausius-Mossotti.
At optical frequencies only survives and : the same equation with is the Lorentz-Lorenz formula.
Worked example. Liquid argon has m⁻³ and m³. Then , so (measured 1.50). Ignoring the local field gives : the local field matters as soon as is not small. As the permittivity diverges: the polarisation catastrophe, where a soft optical mode freezes and the crystal becomes ferroelectric (BaTiO₃).
Separating the mechanisms. Plot (for a gas) against : the intercept gives , the slope gives . Comparing at low frequency with at optical frequency separates ionic from electronic parts.
2. Debye relaxation: dipoles that lag
Permanent dipoles align with a relaxation time (picoseconds for water). If relaxes towards its static value as , a field gives
- Step in `$\varepsilon'$`
- from `$\varepsilon_s$` (dipoles follow) to `$\varepsilon_\infty$` (dipoles frozen), centred on `$\omega\tau = 1$`
- Loss peak
- `$\varepsilon''_{\max} = (\varepsilon_s - \varepsilon_\infty)/2$` at `$\omega\tau = 1$`; full width 1.14 decades on a log scale
- Cole-Cole plot
- `$\varepsilon''$` against `$\varepsilon'$` is a semicircle of radius `$(\varepsilon_s - \varepsilon_\infty)/2$`; a flattened arc means a spread of relaxation times
- Power absorbed
- per volume `$\tfrac12\omega\varepsilon_0\varepsilon''E_0^2$`; loss tangent `$\tan\delta = \varepsilon''/\varepsilon'$`
Worked example. Water near room temperature: , , ps. The loss peaks at GHz with . A microwave oven runs at 2.45 GHz, well below the peak (): , enough to heat food yet small enough that the waves get a few centimetres in before they are absorbed.
3. Bound charges: the Lorentz oscillator
An electron (or ion) on a spring of natural frequency with damping : . With such oscillators per volume and :
Below ω₀. ε′ > 1 and rises with ω: normal dispersion (blue light bends more in glass).
Near ω₀. ε″ peaks with width γ (absorption line); ε′ falls with ω: anomalous dispersion.
Between ω₀ and √(ω₀² + ωp²). With little damping ε′ < 0: no wave propagates, and the crystal reflects almost perfectly. For ionic crystals this is the reststrahlen band in the infrared.
Far above. ε → 1 − ωp²/ω²: the charges respond as if free.
For an ionic crystal with a background from the electrons, the zero of (a longitudinal wave can exist only where ) sits at the longitudinal optical frequency , the pole at the transverse frequency . That gives the Lyddane-Sachs-Teller relation (see also phonons):
NaCl: , , cm⁻¹, so cm⁻¹, close to the measured 264 cm⁻¹. NaCl reflects strongly between about 61 and 38 μm.
4. Free electrons: the Drude metal
Set (no restoring force) and call the damping :
- `$\omega < \omega_p$` (with `$\gamma \ll \omega$`)
- `$\varepsilon' < 0$`, the index `$\tilde n = n + i\kappa$` is almost purely imaginary, and `$R = |(\tilde n - 1)/(\tilde n + 1)|^2 \approx 1$`: metals shine
- `$\omega > \omega_p$`
- `$\varepsilon' > 0$`, the metal transmits: the ultraviolet transparency of the alkali metals
- `$\omega = \omega_p$`
- `$\varepsilon = 0$`: a longitudinal collective oscillation of the electron gas, the plasmon (seen as energy-loss peaks of fast electrons)
- Low frequency, `$\omega\tau \ll 1$`
- `$\varepsilon'' = \sigma_0/\varepsilon_0\omega$` dominates; fields fall off over the skin depth `$\delta = \sqrt{2/\mu_0\sigma_0\omega}$`
- Absorption coefficient
- `$\alpha = 2\omega\kappa/c$` for any medium, from the intensity `$e^{-\alpha z}$`
Worked example. Sodium has one conduction electron per atom, m⁻³. Then rad/s, eV and nm. Sodium is a mirror in the visible and transparent below about 210 nm, as measured. For copper at 1 GHz, S/m gives m, which is why microwave conductors need only a thin plating.
In real metals the bound electrons add a background: , so the edge moves to . Interband absorption from the d bands gives copper and gold their colour by cutting the reflectivity in the blue. In a doped semiconductor, use and the lattice permittivity: , which puts the edge in the infrared.
5. Causality: Kramers-Kronig
Because the polarisation cannot come before the field, is analytic in the upper half of the complex -plane (see complex analysis). This ties the two parts together:
Every absorption band therefore produces dispersion, and the static counts all the absorption at every frequency. A related sum rule fixes with the total electron density.
“A material with ε′ < 0 absorbs the light.” Negative with small means the wave cannot travel in, but nothing is absorbed: the energy comes back out as reflection. Absorption needs . A good metal below and NaCl in its reststrahlen band are nearly perfect mirrors for this reason, and the small loss that remains () comes from .
- Lorentz local field ; Clausius-Mossotti ; Lorentz-Lorenz with ; catastrophe at .
- ; mechanisms drop out in UV, IR and microwave in turn.
- Debye: ; loss peak at ; Cole-Cole semicircle.
- Lorentz oscillator: normal and anomalous dispersion; reflecting band from to ; LST .
- Drude: , ; below , transparent above; plasmon at ; skin depth .
- Kramers-Kronig: causality links and ; every absorption brings dispersion.
Practise: exam questions on this lesson
Next: lesson 9.4 confines electrons to two dimensions and puts them in a strong magnetic field. For how ε(ω) sets the reflection at an interface, see Fresnel equations and waves in media.
Check yourself
Sources
- C. Kittel, Introduction to Solid State Physics, 8th ed. (2005), chapters 14 and 15 and appendix
- M. Fox, Optical Properties of Solids, 2nd ed. (2010), chapters 2 and 7
- N. W. Ashcroft and N. D. Mermin, Solid State Physics (1976), chapters 1 and 27
- CSIR-UGC NET Physical Sciences syllabus, Part C condensed matter physics, published by the National Testing Agency
Your ticks stay in this browser. Save them as a file on the course home.
Updated 2026-11-22. Not affiliated with CSIR, UGC or the National Testing Agency. Check the official CSIR NET website for the current pattern. All questions are original.