Home / Learn / Exam prep / GATE Physics / Lesson 3.6
All lessons

Module 3: Electromagnetic theory · Lesson 3.6 · about 60 min

Electromagnetic waves in matter, conductors and plasmas

Waves in linear dielectrics and the intrinsic impedance, complex permittivity and the loss tangent, good and poor conductors (skin depth, the 45° lag of B, surface resistance), charge relaxation, cold plasmas (dispersion, cutoff, evanescent waves, ionospheric reflection), the Drude and Lorentz models, group velocity and the Kramers-Kronig relations.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 3 · about 60 minutes. By the end you will be able to describe a plane wave in any linear medium by one complex wavenumber, decide whether a material acts as a conductor or a dielectric at a given frequency, compute skin depths, surface resistance and energy ratios in metals, handle the cold-plasma dispersion relation with its cutoff, read the Drude and Lorentz models, and work with group velocity and the Kramers-Kronig idea. The vacuum basics (plane waves, Poynting vector, impedance η0) are in the JAM lesson on Maxwell’s equations and electromagnetic waves.

Every linear medium is summed up by one complex number at each frequency, its permittivity. Its real part slows the wave; its imaginary part (or a conductivity) eats it. Metals, plasmas and glass are the same equations with different numbers.

1. One complex wavenumber for every linear medium

In a homogeneous medium with permittivity ϵ, permeability μ and conductivity σ, Maxwell’s equations with J→=σE→ give, for fields ∝ei(k~z−ωt),

k~2=μϵω2+iμσω=μω2(ϵ+iσω)

So a conductivity is the same as an imaginary part of the permittivity, ϵ′′=σ/ω. Write k~=k+iκ: the fields go as e−κzcos⁡(kz−ωt), with wavelength 2π/k and 1/e length 1/κ. The magnetic field follows from Faraday’s law, B~=(k~/ω)E~, so a complex k~ also puts B out of phase with E.

The single number that decides everything is the loss tangent, the ratio of conduction to displacement current:

tan⁡δ=σωϵ
  • σ≪ωϵ: a low-loss dielectric. k≈ωμϵ and κ≈σ2μ/ϵ, independent of frequency.
  • σ≫ωϵ: a good conductor. k~≈(1+i)/δ with δ=2/(μσω).

The same material can be both: sea water (σ=4 S/m, ϵr=81) is a good conductor below about 100 MHz and a lossy dielectric at optical frequencies. For lossless dielectrics, the intrinsic impedance η=μ/ϵ=η0μr/ϵr replaces 377 Ω: water at radio frequencies has η≈42 Ω.

Worked example. Soil with σ=0.01 S/m and ϵr=10 at 10 MHz: ωϵ=5.6×10−3 S/m, so tan⁡δ=1.8. Neither limit holds, and you must take the square root of k~2 exactly. Ground-penetrating radar engineers live in this awkward middle.

k̃ = k + iκ
complex wavenumber: k sets the wavelength, κ the decay
ε'' = σ/ω
imaginary permittivity: any loss mechanism, conduction included
tan δ = σ/ωε
loss tangent: conduction current over displacement current
δ = √(2/μσω)
skin depth of a good conductor: the field falls by e in this distance
ωp = √(ne²/mε₀)
plasma frequency: below it free electrons screen the wave out
Physical meaning
A medium is a crowd of charges driven by the wave. If they keep up in phase (bound electrons far below resonance), the wave is slowed; if they lag by 90° (free electrons), they reflect it; if they lag in between, they absorb it.

2. Good conductors: skin depth, phase and surface resistance

With k~=(1+i)/δ, five facts follow at once:

  1. The amplitude falls as e−z/δ; the power as e−2z/δ, i.e. 8.686 dB per skin depth.
  2. The wavelength inside is 2πδ and the phase velocity ωδ, tiny (copper at 1 GHz: δ=2.1 μm, vp≈13 km/s). Since ω∝k2, the group velocity is 2vp.
  3. k~=2δeiπ/4, so B lags E by 45°, and B0/E0=μσ/ω≫1/c.
  4. The energy is mostly magnetic: uB/uE=σ/(ωϵ), about 109 for copper at 1 GHz.
  5. The current flows in a layer about δ thick, so a square of surface has resistance Rs=1/(σδ)=μω/2σ. The time-averaged power absorbed per unit area is 12Rs|H0|2, where H0 is the tangential magnetic field at the surface.

Worked example. Aluminium at 50 Hz: δ=2/(1.2566×10−6×3.5×107×314)=12 mm. Thick power conductors therefore carry current mainly in their outer centimetre. Copper at 10 GHz: Rs=πfμ0/σ=26 mΩ; a cavity wall where H0=20 A/m loses 12×0.026×400=5.2 W/m².

The surface impedance of a good conductor is ηc=Rs(1−i) (with e−iωt), with magnitude μω/σ≪η0. That mismatch is why metals reflect: 1−R≈4Rs/η0, about 3×10−4 for copper at 10 GHz.

Charge relaxation. Gauss plus continuity plus Ohm give ∂ρf/∂t=−(σ/ϵ)ρf. Free charge inside a conductor disappears with time constant τ=ϵ/σ (1.5×10−19 s for copper, far shorter than any wave period), which is why we set ρf=0 inside metals.

3. Cold plasmas: dispersion, cutoff and the ionosphere

Free electrons obey mv→˙=−eE→, so for e−iωt, J→=ine2mωE→: a purely imaginary conductivity, current 90° out of phase, no loss. Then

ϵ(ω)=ϵ0(1−ωp2ω2),ω2=ωp2+c2k2,ωp2=ne2mϵ0

Numerically fp≈8.98n Hz (with n in m⁻³). The dispersion relation has the form of E2=m2c4+p2c2: the plasma gives light an effective mass.

  • Above cutoff (ω>ωp): n=1−ωp2/ω2<1, vp=c/n>c, vg=cn<c, and vpvg=c2.
  • Below cutoff: k=iκ with κ=ωp2−ω2/c. The field decays without travelling, its average Poynting vector is zero, and the wave is totally reflected.
Plasma view: the dispersion curve against the light line; the slope of the chord is the phase velocity and the slope of the curve the group velocity. Conductor view: a snapshot of the field inside a metal, decaying within a few skin depths, for any metal and frequency.

Worked example: oblique reflection. An ionospheric layer with peak density 2.5×1012 m⁻³ has fp=14.2 MHz. A ray entering at angle θ from the vertical turns back where n=sin⁡θ (Snell in a flat, layered medium), i.e. where fp=fcos⁡θ. At θ=70∘ the layer reflects up to 14.2/cos⁡70∘=42 MHz, which is why short-wave radio reaches beyond the horizon while FM (100 MHz) does not.

Worked example: dispersion of pulsar signals. For f≫fp the extra group delay over a path is t=e28π2ϵ0mec∫ndlf2. With 30 pc cm⁻³ of electrons, the 400 MHz pulse lags the 800 MHz pulse by 0.58 s; astronomers read the electron column straight off the sweep.

4. Drude and Lorentz: metals and dielectrics as driven oscillators

Add collisions (time τ) to the free electrons and you get the Drude conductivity

σ(ω)=σ01−iωτ,σ0=ne2τm

For ωτ≪1 it is Ohm’s law; for ωτ≫1 it becomes the lossless plasma with ωp2=σ0/(ϵ0τ). Metals have n∼1028 m⁻³ and ωp in the ultraviolet, so they reflect visible light and become transparent in the ultraviolet: sodium turns transparent below about 205 nm.

Give the electrons a spring (bound charges, natural frequency ω0, damping γ) and you get the Lorentz model:

ϵ(ω)ϵ0=1+Ne2mϵ01ω02−ω2−iγω

Far below ω0 the refractive index is above 1 and rises with frequency (normal dispersion: blue bends more than red). Near ω0 the imaginary part peaks (absorption, full width γ) and n falls with frequency across the line (anomalous dispersion), with its maximum and minimum at ω0∓γ/2. Setting ω0=0 gives back the free-electron plasma.

5. Group velocity and causality

A pulse moves at vg=dω/dk. With k=nω/c:

vg=cn+ωdn/dω=cn−λdn/dλ

Worked example. Glass with n=1.52 and dn/dλ=−0.050 μm⁻¹ at 500 nm: group index 1.52+0.025=1.545, so vg=1.94×108 m/s, slower than vp=1.97×108 m/s.

Inside an absorption line n+ωdn/dω can drop below 1 or go negative, so “vg>c” appears. No signal beats light: the pulse is heavily absorbed and reshaped, and the front of a switched-on signal travels at the high-frequency limit where n→1.

Causality also ties absorption to refraction. Because the polarisation cannot precede the field, ϵ(ω) is analytic in the upper half of the complex ω plane, and its real and imaginary parts are linked by the Kramers-Kronig relations (the contour methods of lesson 1.4 on residues):

ϵ′(ω)−ϵ0=2πPV∫0∞ω′ϵ′′(ω′)ω′2−ω2dω′

Two consequences: a material that absorbed nowhere would have ϵ=ϵ0 everywhere, and every absorption band raises the index at frequencies below it. Glass is transparent and has n>1 in the visible because it absorbs in the ultraviolet.

“A decaying wave means energy is being absorbed.” Not necessarily. Below the plasma frequency the field decays as e−κz in a perfectly lossless plasma: E and B are 90° out of phase, the average Poynting vector is zero, and all the energy is reflected. Absorption needs a real part of the conductivity (collisions), not just an imaginary wavenumber. The same holds for evanescent waves in total internal reflection and below-cutoff waveguides.

  • k~2=μω2(ϵ+iσ/ω); tan⁡δ=σ/ωϵ decides conductor or dielectric, at each frequency.
  • Low-loss: κ≈σ2μ/ϵ (frequency independent). Lossless: η=η0μr/ϵr.
  • Good conductor: k~=(1+i)/δ, δ=2/μσω; λ=2πδ, vp=ωδ, vg=2vp; B lags E by 45°; uB/uE=σ/ωϵ; Rs=1/σδ, loss 12RsH02; 1−R≈4Rs/η0.
  • Charge relaxation τ=ϵ/σ.
  • Plasma: ω2=ωp2+c2k2, fp=8.98n Hz, vpvg=c2; below cutoff evanescent with 1/κ=c/ωp2−ω2; oblique reflection up to fpsec⁡θ; delay ∝1/f2.
  • Drude σ0/(1−iωτ); metals transparent above ωp (ultraviolet). Lorentz: normal dispersion away from lines, anomalous inside, extremes at ω0∓γ/2.
  • vg=c/(n+ωdn/dω); Kramers-Kronig from causality: absorption below raises n.

Practise: exam questions on this lesson

From warm-up to top-rank level, with full solutions. More on the practice page.

Before this: the JAM lesson on Maxwell’s equations and electromagnetic waves and, for group velocity in general, waves. Next: lesson 3.7, the Fresnel equations, where these media meet at a boundary. Back to the GATE Physics course home.

Going on to CSIR NET? Plasma oscillations and dispersion goes further with the plasma frequency and cutoffs.

Check yourself

1A 2 MHz wave meets a plasma whose plasma frequency is 5 MHz. What happens?
2When a material is a good conductor, how does the skin depth change if the frequency is made 4 times larger?
3In a good conductor, which carries most of a wave's energy?

Sources

  • D. J. Griffiths, Introduction to Electrodynamics, 4th ed. (2017), chapter 9.3 and 9.4
  • J. D. Jackson, Classical Electrodynamics, 3rd ed. (1999), chapter 7
  • F. F. Chen, Introduction to Plasma Physics and Controlled Fusion, 3rd ed. (2016), chapter 4
  • E. Hecht, Optics, 5th ed. (2017), chapter 3.5 (dispersion)
  • GATE Physics (PH) syllabus, Electromagnetic Theory section, published by the organising institute each year

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Not affiliated with the IITs, IISc or the GATE organising institute. The general aptitude part of GATE is not covered here. Check the official GATE website for the current pattern. All questions are original.