Home / Learn / Exam prep / IIT JAM Physics / Lesson 4.2
All lessons

Module 4: Electricity and magnetism · Lesson 4.2 · about 40 min

Potential and electrostatic energy

Electric potential as a single number at each point: getting V from E and E from V, equipotentials, dipoles, the work to assemble charges, field energy density, self-energy of spheres and shells, and Poisson's and Laplace's equations.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 4 · about 40 minutes. By the end you will be able to find the potential of point charges, rings, spheres and lines, get the field back from a potential with E→=−∇V, work out the energy of a set of charges and of a continuous distribution, and use Poisson’s and Laplace’s equations to read off a charge density.

Because the electrostatic field is conservative, one number at each point, the potential, carries all the information of the three field components, and it adds without any vectors.

1. Why a potential exists

In lesson 4.1 you saw that ∇×E→=0 for any static charges. A curl-free field is the gradient of something (lesson 1.5), so we can write

E→=−∇V,V(b)−V(a)=−∫abE→⋅dl→

The minus sign is a choice that makes V behave like a hill: the field points downhill, from high potential to low. Only differences of V are physical; we usually set V=0 at infinity.

For a point charge, integrating kq/r2 in from infinity gives

V(r)=q4πϵ0r

Potentials of several charges add as plain numbers. No components, no angles. That is the whole point.

Worked example. Charges +q,+q,−q,+q (q=1 nC) at the corners of a 20 cm square. Every corner is a/2=0.141 m from the centre, so V=k(q+q−q+q)/0.141=k(2q)/0.141≈127 V. Treating potentials as vectors and cancelling corners is the trap.

V
potential energy per unit charge at a point (volts = joules per coulomb)
−∇V
the field: points the way V falls fastest
qΔV
energy a charge q gains or loses moving through a potential difference ΔV
Equipotential
a surface of constant V; field lines cross it at right angles and no work is done moving along it
Physical meaning
V is a height map for charges. Positive charges roll downhill, negative ones uphill, and the slope is the field.

2. From V to E and back

From E to V you integrate along any path (the result does not depend on the path). From V to E you differentiate: Ex=−∂V/∂x and so on.

Worked example. V=3x2y volts. Then E→=−(6xyiˆ+3x2jˆ), which at (1,2,0) is −12iˆ−3jˆ V/m. The option without the minus sign is always there.

Three facts that settle many statement questions:

  • Where V is constant, E→=0 (inside a conductor, for example, V is the same as at its surface, not zero).
  • V=0 does not mean E=0: midway between +q and −q, V=0 but the field is strong.
  • E=0 does not mean V=0: midway between two equal charges the field cancels but the potentials add.

Explore it below. Pick a charge set, switch on the equipotentials, and tap to probe V and |E→|. Notice that the field lines always cross the dotted curves at right angles, and that the field is strongest where the equipotentials crowd together.

Equipotentials (dotted) and field lines (solid) for point charges. The probe reads V and |E| in units of kq/d and kq/d².

3. Potentials of the standard shapes

Source Potential Note
Point charge kq/r zero at infinity
Dipole p→ kpcos⁡θr2 falls as 1/r2; the field as 1/r3
Ring Q, radius R, on axis kQR2+z2 every piece is at the same distance
Shell Q, radius R kQ/r outside, kQ/R inside constant inside (no field)
Uniform solid sphere kQ(3R2−r2)2R3 inside 1.5kQ/R at the centre
Infinite line λ −λ2πϵ0ln⁡ss0 cannot be zero at infinity

Worked example: concentric shells. Shells of radii 10 cm and 20 cm carry +2 nC and −1 nC. Inside both, each shell contributes its surface value: V(0)=k(2/0.10−1/0.20)×10−9≈135 V. The outer shell has no field inside it, yet it still raises the potential there; dropping it is the common slip.

The line charge. Integrating λ/(2πϵ0s) gives a logarithm, which never settles down as s→∞. The charge itself reaches to infinity, so infinity cannot be the reference; pick any finite s0. The potential difference between radii a and b, λ2πϵ0ln⁡ba, is all you ever need.

4. Work and the energy of a set of charges

Bringing a charge q from infinity to a point at potential V takes work qV. Build up a set of charges one at a time and you get

W=14πϵ0∑pairsqiqjrij=12∑iqiVi

where Vi is the potential at charge i due to all the others (the 12 stops each pair being counted twice).

Worked example. Four 1 μC charges at the corners of a 10 cm square: four side pairs at a and two diagonal pairs at a2. W=kq2a(4+2)≈0.487 J. Forgetting the diagonals gives 0.360 J.

Energy and motion. A particle of charge q released from rest at potential V1 has kinetic energy q(V1−V2) at V2. An alpha particle (+2e) going from +150 V to −250 V gains 2×400=800 eV. Keep the sign of the charge and the order of subtraction straight, and electron-volts make the arithmetic trivial.

A dipole in a uniform field has energy U=−p→⋅E→: lowest when aligned. Turning it from aligned to reversed costs 2pE.

5. Energy stored in the field

For a continuous charge, the same idea becomes W=12∫ρVdτ, and with Gauss’s law this can be rewritten entirely in terms of the field:

W=ϵ02∫all spaceE2dτ,u=12ϵ0E2 per unit volume

Step through the standard results for a sphere of charge Q and radius R:

Outside any sphere. E = kQ/r². The energy beyond radius R is ∫ ½ε₀E² 4πr² dr from R to ∞ = kQ²/(2R).

Thin shell. No field inside, so that is all: W = kQ²/(2R).

Uniform solid sphere. Inside E = kQr/R³, which adds kQ²/(10R). Total W = (1/2 + 1/10) kQ²/R = (3/5) kQ²/R.

Where it sits. For the solid sphere, (1/2)/(3/5) = 5/6 of the energy is outside the sphere and only 1/6 inside.

“Electrostatic energy can be negative, so ½ε₀∫E² must be wrong.” Both are right. ϵ02∫E2 is never negative because it includes the (infinite) self-energy of each point charge. The pair formula kq1q2/r is only the interaction part, the cross term ϵ0∫E→1⋅E→2, which can be negative. Energies do not add when fields do: (E→1+E→2)2≠E12+E22.

Worked example. Air breaks down near 3×106 V/m, where u=12ϵ0E2≈40 J/m³. A 1 T magnetic field stores about 4×105 J/m³ (lesson 4.7): this is why motors are magnetic, not electric.

6. Poisson’s and Laplace’s equations

Put E→=−∇V into ∇⋅E→=ρ/ϵ0:

∇2V=−ρϵ0  (Poisson),∇2V=0 where there is no charge  (Laplace)

Worked example. V=V0(x2+y2+z2)/a2 has ∇2V=6V0/a2, so ρ=−6ϵ0V0/a2. And a(x2−y2), axy or e−kxsin⁡ky all satisfy Laplace’s equation, so they can exist in empty space. Solving Laplace’s equation with boundary conditions is lesson 4.3; the 2D electrostatics solver does it numerically for any electrodes you draw.

  • E→=−∇V, ΔV=−∫E→⋅dl→. The field points from high to low potential.
  • Potentials add as numbers: point charge kq/r, ring kQ/R2+z2, shell constant inside, solid sphere 1.5kQ/R at the centre, dipole kpcos⁡θ/r2.
  • V=0 and E=0 are independent statements; a constant V region has zero field.
  • Work to assemble charges: sum kqiqj/rij over pairs. Kinetic energy gained: q(V1−V2).
  • Field energy 12ϵ0E2 per volume. Shell kQ2/2R, uniform sphere 3kQ2/5R.
  • Poisson ∇2V=−ρ/ϵ0; Laplace ∇2V=0 in charge-free space.

Practise: exam questions on this lesson

These start easy and climb to top-rank level. Check each answer, then read the full solution. More on the potential and energy practice page.

Next: lesson 4.3 puts conductors into the picture, solves Laplace’s equation and introduces the method of images; after that come dielectrics and capacitors. Back to the field picture: electric fields and Gauss’s law. For multipole expansions and boundary value problems at MSc level, see the GATE Physics course.

Check yourself

1Midway between charges +q and −q, what are the potential and the field?
2An electron is released from rest. Which way does it move?
3The same charge is put (a) on a thin shell and (b) uniformly through a solid sphere of the same radius. Which stores more energy?

Sources

  • D. J. Griffiths, Introduction to Electrodynamics, 4th ed. (2017), chapter 2: electric potential, work and energy
  • E. M. Purcell and D. J. Morin, Electricity and Magnetism, 3rd ed. (2013), chapter 2
  • H. C. Verma, Concepts of Physics, Part 2 (1993), chapter 29
  • IIT JAM Physics syllabus (Electricity and Magnetism section), published by the organising IIT each year

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Not affiliated with IIT or the JAM organising institute. Exam pattern as published for recent years: always check the official JAM website before the exam. All questions are original.