Home / Learn / Exam prep / IIT JAM Physics / Lesson 4.7
All lessons

Module 4: Electricity and magnetism · Lesson 4.7 · about 45 min

Electromagnetic induction and inductance

Faraday's and Lenz's laws, motional EMF in rods, rotating rods and generators, the induced electric field of a changing B, self and mutual inductance, RL growth and decay, magnetic energy, and the rod-on-rails problems that examiners vary endlessly.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 4 · about 45 minutes. By the end you will be able to find the EMF from a changing flux or from motion, get its direction from Lenz’s law without guessing, work out the induced electric field round a solenoid, compute self and mutual inductances, solve RL circuits and their energy, and handle every variant of the rod on rails.

Whenever the magnetic flux through a loop changes, for any reason, an EMF appears round the loop, and it always pushes current the way that fights the change.

1. Faraday’s law

The magnetic flux through a loop is Φ=∫B→⋅da→ (in webers, T m²). Faraday found that an EMF appears round the loop whenever Φ changes:

ℰ=−dΦdt,for N turns: ℰ=−NdΦdt

The flux can change because B changes, because the loop’s area changes, or because the loop turns. Faraday’s law covers all three.

Worked example. 200 turns of area 0.010 m² in 0.50 T; the field falls to zero in 0.10 s. |ℰ|=NΔΦ/Δt=200×0.0050/0.10=10 V.

Charge does not care about speed. The charge that flows is Q=∫Idt=NΔΦ/R, whatever the rate. Flip a coil through 180∘ and ΔΦ=2BA: a fast flip gives a big current for a short time, a slow flip a small one for longer, and the same charge.

Φ
how much magnetic field threads the loop (field × area × cos angle)
dΦ/dt
how fast that threading changes, for any reason
ℰ
the push round the loop, in volts: the work done per coulomb taken once round
minus sign
Lenz's law: the induced current makes a flux that opposes the change
Physical meaning
Nature resists changes in magnetic flux. Push a magnet in, the coil pushes back; pull it out, the coil pulls back. That resistance is what generators turn into electrical energy.

2. Lenz’s law: getting the direction

Never guess the direction. Use three steps: (1) which way does the flux through the loop point, and is it growing or shrinking? (2) the induced current makes its own field against the change (opposite to the flux if it is growing, along it if it is shrinking); (3) the right-hand rule turns that field into a current direction.

Watch it in the figure. The coil’s face nearest the approaching pole becomes the same pole and pushes back; as the magnet leaves, the current reverses and pulls it back. Stop the magnet and everything stops, however strong the field.

A magnet moving along a coil's axis. The graph shows the flux and the EMF, which is minus its slope: biggest where the flux changes fastest, zero when the magnet is centred or still.

“The induced current opposes the magnetic field.” It opposes the change in flux. If the flux through a loop is falling, the induced current flows so as to keep it up, making a field in the same direction as the original one. A falling magnet is slowed both while it approaches a ring and while it leaves it.

3. Motional EMF

A rod of length L moving at v through a field B (all three perpendicular): each charge in it feels qvB along the rod, which is an EMF

ℰ=BLv

This is Faraday’s law again: as the rod slides on rails, the circuit’s area grows at Lv per second. Variants worth knowing:

  • Rod spinning about one end at ω: a piece at radius r moves at ωr, so ℰ=∫0LBωrdr=12BωL2 (average speed 12ωL). About its midpoint the two halves cancel between the ends.
  • Generator coil of N turns, area A, spinning at ω: Φ=NBAcos⁡ωt, so ℰ=NBAωsin⁡ωt, peak NBAω, rms peak/2.
  • Loop moving away from a long wire: only the two sides parallel to the wire count, and they oppose: ℰ=μ0Iav2π(1s−1s+b).

Worked example. A 1.0 m rod spins at 10 rev/s in 0.20 T: ω=62.8 rad/s and ℰ=12(0.20)(62.8)(1.0)2≈6.28 V. Using the tip speed for the whole rod doubles it.

4. Rods on rails

This one setup produces dozens of exam questions. A rod (mass m, length L) on frictionless rails closed by a resistor R, in a field B perpendicular to the rails:

EMF and current. At speed v, ℰ = BLv and I = BLv/R.

The brake. The current in the rod feels BIL = B²L²v/R, always against the motion (Lenz).

Pulled by a constant force F. Speed rises to a terminal value where B²L²v/R = F: vt = FR/(B²L²). Then all the work done by F becomes heat in R.

Given a kick v₀ and left alone. m dv/dt = −B²L²v/R: v decays exponentially in time, but dv/dx = −B²L²/(mR) is constant, so v falls linearly with distance and the rod stops after x = mv₀R/(B²L²).

A capacitor instead of the resistor. I = C d(BLv)/dt = CBLa, so F − CB²L²a = ma: constant acceleration F/(m + CB²L²). The capacitor acts like extra mass.

5. The induced electric field

When B changes in time, Faraday’s law holds even with no wire present: there is a real electric field circling the changing flux,

∮E→⋅dl→=−dΦdt,∇×E→=−∂B→∂t

This field is not conservative (its curl is not zero), so it cannot be written as −∇V, and the idea of “voltage between two points” becomes path-dependent.

Worked example: a solenoid of radius R with dB/dt inside. A circle of radius r gives E⋅2πr=πr2dB/dt inside, so E=r2dBdt; outside it links all the flux, so E=R22rdBdt. The field outside is not zero even though B is. A betatron uses this field to accelerate electrons; keeping them on a fixed circle needs the field at the orbit to be half the average field inside it.

6. Inductance

A current I in a coil makes a flux through itself proportional to I: NΦ=LI. A changing current then induces a back-EMF −LdI/dt. Similarly a current in coil 1 threads coil 2: N2Φ2=MI1, and remarkably M12=M21 always.

Shape Inductance
Long solenoid, N turns, length l, area A L=μ0N2A/l
Toroid, rectangular section a to b, height h L=μ0N2h2πln⁡ba
Coaxial cable, per metre μ02πln⁡ba
Coaxial solenoids (inner radius r1) M=μ0n1n2πr12l
Long wire and coplanar rectangle M=μ0a2πln⁡d+bd

Trick: compute M the easy way round. For a small loop near a big one, send the current through the big loop (whose field you know) and find the flux through the small one; M12=M21 then gives you the hard direction for free.

Coupled coils. M=kL1L2 with 0≤k≤1. In series, L=L1+L2±2M (plus if the fluxes add). With 4 mH and 9 mH, M can never exceed 6 mH.

7. RL circuits and magnetic energy

Connect a battery V to R and L in series at t=0:

I(t)=VR(1−e−t/τ),τ=LR

After one time constant the current is 63% of its final value. Short the battery out and it decays as I0e−t/τ.

The energy needed to set up the current is stored in the magnetic field:

U=12LI2,u=B22μ0 per unit volume

Worked example. A 0.50 H coil carrying 2.0 A discharges through 5.0 Ω. τ=0.10 s. The energy, ∝I2, falls as e−2t/τ, so it halves at τln⁡2/2=34.7 ms, not at 69.3 ms. In total 12LI02=1.0 J becomes heat. The capacitor inductor calculator gives RL time constants and the inductance of solenoids, toroids and cables.

For two coils, U=12L1I12+12L2I22+MI1I2; asking that this is never negative is exactly the condition M2≤L1L2.

  • ℰ=−NdΦ/dt, whatever changes the flux. Charge through a circuit =NΔΦ/R; a flip changes the flux by 2BA.
  • Lenz: the induced current opposes the change in flux (not the flux). Always slows relative motion.
  • Motional EMF BLv; spinning rod 12BωL2; generator peak NBAω.
  • Rails: terminal speed FR/B2L2; coasting rod stops in mv0R/B2L2 (speed linear in distance); with a capacitor, constant acceleration F/(m+CB2L2).
  • ∇×E→=−∂B→/∂t: round a solenoid E=r2B˙ inside, R22rB˙ outside.
  • L=μ0N2A/l, M=kL1L2, series L1+L2±2M. RL: τ=L/R; energy 12LI2, B2/2μ0 per volume.

Practise: exam questions on this lesson

These start easy and climb to top-rank level. Check each answer, then read the full solution. More on the induction practice page.

Next: lesson 4.8 builds on inductance for DC transients and AC circuits, and lesson 4.9 adds the displacement current to complete Maxwell’s equations. The fields that change here were made by the currents of magnetic fields: Biot-Savart and Ampère. For potentials, gauges and electromagnetic waves at MSc level, see the GATE Physics course.

Check yourself

1A magnet is held still inside a coil. What EMF is induced?
2A coil is flipped through 180° in a uniform field. By how much does the flux through it change?
3An inductor's current decays as I₀e^(−t/τ). When has its stored energy halved?

Sources

  • D. J. Griffiths, Introduction to Electrodynamics, 4th ed. (2017), chapter 7: electrodynamics
  • E. M. Purcell and D. J. Morin, Electricity and Magnetism, 3rd ed. (2013), chapter 7
  • H. C. Verma, Concepts of Physics, Part 2 (1993), chapter 38
  • IIT JAM Physics syllabus (Electricity and Magnetism section), published by the organising IIT each year

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Not affiliated with IIT or the JAM organising institute. Exam pattern as published for recent years: always check the official JAM website before the exam. All questions are original.