Home / Learn / Exam prep / GATE Physics / Lesson 7.10
All lessons

Module 7: Solid state physics · Lesson 7.10 · about 55 min

Superconductivity

Superconductivity at MSc level: zero resistance and the Meissner effect, the critical field and critical current, London equations and the penetration depth, thermodynamics of the transition, coherence length and type-I versus type-II behaviour, vortices and flux quantisation, BCS theory with the gap and the isotope effect, Josephson effects, SQUIDs and the cuprates.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Module 7 · about 55 minutes. By the end you will be able to tell a superconductor from a perfect conductor, use the critical-field curve, the London penetration depth and the two-fluid model, work out condensation energies and heat-capacity jumps, classify a material as type I or II from λ and ξ, count vortices and flux quanta, apply the BCS gap and isotope relations, and use the Josephson relations and SQUIDs. You will use the free electron gas of lesson 7.6, the diamagnetism of lesson 7.9, and Maxwell’s equations from the JAM lesson.

Below T_c, electrons near the Fermi surface bind into Cooper pairs and condense into one coherent quantum state, a single wavefunction spread over the whole sample. That one fact explains zero resistance, the expulsion of magnetic fields, flux in units of h/2e, an energy gap of a few k_BT_c, and currents that tunnel through thin barriers as Josephson currents.

1. Zero resistance and the Meissner effect

Many metals lose all resistance below a critical temperature Tc (Hg 4.2 K, Pb 7.2 K, Nb 9.2 K). But a superconductor is more than a perfect conductor. Inside a perfect conductor ∂𝐁/∂t=0, so it would keep whatever field it had when it became perfect. A superconductor cooled in a field expels it (Meissner and Ochsenfeld, 1933): B=0 inside, χ=−1, whatever the history. So superconductivity is a true thermodynamic phase.

A strong enough field destroys it. For a type-I material

Bc(T)=Bc(0)[1−(TTc)2]

and a wire fails when its own surface field μ0I/2πa reaches Bc (Silsbee’s rule): Ic=2πaBc/μ0, 75 A for a 0.5 mm radius and 30 mT.

The phase diagram: move the dot with the sliders to see which state a type-I or type-II superconductor is in at temperature T and field B. Below B_c (type I) or B_c1 (type II) the field is expelled; between B_c1 and B_c2 it enters as vortices. The second view shows how far an applied field leaks in: B falls as e^(−x/λ), and λ grows as T approaches T_c (two-fluid model). A perfect conductor cooled in the field would keep it inside (dashed).

2. London equations and the penetration depth

The Londons (1935) wrote two equations for a superfluid of density ns:

∂𝐉s∂t=nse2m𝐄,∇×𝐉s=−nse2m𝐁

The first is free acceleration (zero resistance). The second, combined with ∇×𝐁=μ0𝐉s, gives ∇2𝐁=𝐁/λL2:

B(x)=B0e−x/λL,λL=mμ0nse2
λ_L
London penetration depth: how far fields and screening currents reach in; 53 nm for n_s = 10²⁸ m⁻³
n_s
superfluid density, zero at T_c; two-fluid model n_s/n = 1 − (T/T_c)⁴
λ(T)
λ(0)/√(1 − t⁴): 50 nm at T = 0 becomes 65 nm at 0.8 T_c and diverges at T_c
Physical meaning
The superfluid responds to a field rigidly, by flowing, rather than to its rate of change. The screening currents run in a skin about λ thick.

At depth 3λ the field is down to 5%. A slab of thickness d in a parallel field has B=B0cosh⁡(x/λ)/cosh⁡(d/2λ) from its centre, so films thinner than λ are only partly screened.

3. Thermodynamics of the transition

Expelling a field costs magnetic energy B2/2μ0 per volume, so at Bc that equals the gain in free energy:

gn(T)−gs(T)=Bc2(T)2μ0

For Bc=0.20 T this is 15.9 kJ/m³. Differentiating along the curve gives the entropy difference Sn−Ss=−Bcμ0dBcdT>0: the superconducting state is more ordered.

In a field (0<T<Tc), Sn≠Ss: the transition is first order with latent heat L=T(Sn−Ss).

At zero field (T=Tc), Bc=0, so L=0: second order. Differentiating once more gives a jump in heat capacity, Rutgers’ formula ΔC=Tcμ0(dBcdT)Tc2.

With the parabolic curve, dBc/dT=−2Bc(0)/Tc at Tc, so ΔC=4Bc(0)2/μ0Tc: 770 J m⁻³ K⁻¹ for tin.

Far below Tc, the electronic heat capacity falls as e−Δ/kBT: the signature of an energy gap.

4. Type I, type II and flux quanta

A second length enters: the coherence length ξ, the distance over which the superconducting order can change. The ratio κ=λ/ξ decides how the material reacts to a field. A boundary between normal and superconducting regions costs about 12μ0Hc2(ξ−λ) per area:

  • κ<1/2 (type I: Al, Sn, Pb): positive wall energy, full Meissner effect up to Bc, then normal.
  • κ>1/2 (type II: Nb, NbTi, Nb₃Sn, cuprates): negative wall energy. Above Bc1 flux enters as vortices, each a normal core of radius ξ wrapped in currents of range λ and carrying exactly one flux quantum, until
Bc2=Φ02πξ2=2κBc,Φ0=h2e=2.068×10−15 Wb

For ξ=5 nm, Bc2=13 T, which is why magnets use type-II wire. Vortices form a triangular lattice with spacing a=2Φ0/3B: 69 nm at 0.5 T. A transport current pushes them sideways; if they move they dissipate, so practical conductors need pinning.

Flux quantisation follows from the single-valued pair wavefunction: the flux through a thick ring is nh/2e. The measured 2e (1961) proved the carriers are pairs. A ring of radius 10 μm cooled in 0.10 mT holds πr2B/Φ0=15.2, so traps 15 quanta.

5. BCS theory

Bardeen, Cooper and Schrieffer (1957): the lattice responds slowly to a passing electron and leaves a positive wake that attracts a second electron. This attraction binds electrons (𝐤↑,−𝐤↓) near the Fermi surface into singlet Cooper pairs, which condense into one state. Key results:

2Δ(0)=3.52kBTc,kBTc=1.13ℏωDe−1/N(0)V,ΔCγTc=1.43,ξ0=ℏvFπΔ
  • The gap. Quasiparticles have Ek=ξk2+Δ2≥Δ; photons are absorbed only above 2Δ (88 GHz for aluminium, Tc=1.2 K). Near Tc, Δ≈3.06kBTc(1−T/Tc)1/2.
  • Isotope effect. Tc∝ωD∝M−1/2: mercury with mass 204 instead of 200 has Tc lower by 1%. This pointed to phonons.
  • Condensation energy 12N(0)Δ2=Bc2/2μ0: only electrons within Δ of EF gain energy.
  • Coherence length. For aluminium ξ0≈1.7 μm, far longer than λ: strongly type I.

Worked example. Niobium, Tc=9.2 K: 2Δ=3.52×8.617×10−5×9.2 eV =2.79 meV, so radiation below 675 GHz cannot break pairs.

6. Josephson effects and SQUIDs

Two superconductors separated by a barrier a few nanometres thick share their pair wavefunctions. With phase difference δ:

I=Icsin⁡δ  (DC),dδdt=2eVℏ  (AC: f=2ehV=483.6 GHz/mV)
  • A DC voltage of 10 μV gives a 4.84 GHz alternating supercurrent.
  • Microwaves at f produce constant-voltage Shapiro steps at Vn=nhf/2e (20.7 μV per 10 GHz), the basis of the volt standard.
  • A SQUID (two junctions in a loop) has a critical current 2Ic|cos⁡(πΦ/Φ0)|, periodic in flux with period Φ0. With 1 mm² that is 2 nT per period, and a small fraction of a period can be resolved.

Cuprates (YBa₂Cu₃O₇, Tc=92 K, above liquid nitrogen) are extreme type II (ξ∼1.5 nm, κ∼100) with a d-wave gap that has nodes, giving power-law rather than exponential low-temperature behaviour, and only a weak isotope effect.

“A superconductor is just a metal with zero resistance.” Zero resistance alone would freeze whatever field was inside. The Meissner effect, active expulsion, shows a new thermodynamic phase.

“Cooper pairs are tightly bound molecules.” In a conventional superconductor a pair extends over ξ0, hundreds of nanometres, overlapping millions of other pairs. It is a correlation in momentum space, not a little molecule.

  • Meissner: B=0 inside (χ=−1); Bc(T)=Bc(0)[1−(T/Tc)2]; Silsbee Ic=2πaBc/μ0.
  • London: λL=m/μ0nse2, B=B0e−x/λ; two-fluid λ(T)=λ(0)/1−t4.
  • gn−gs=Bc2/2μ0; first order in a field, second order at B=0; Rutgers ΔC=(Tc/μ0)(dBc/dT)2.
  • κ=λ/ξ: type II if >1/2; Bc2=Φ0/2πξ2=2κBc; Φ0=h/2e.
  • BCS: 2Δ=3.52kBTc, ΔC=1.43γTc, Tc∝M−1/2, C∝e−Δ/kBT, ξ0=ℏvF/πΔ.
  • Josephson: I=Icsin⁡δ, f=2eV/h, steps at nhf/2e; SQUID period Φ0.

Practise: GATE questions on this lesson

They start easy and climb to top-rank level. More on the GATE Physics practice page.

Next: module 8 turns to the nucleus, starting with nuclear size, spin and moments. The Superconductor calculator works out critical fields, penetration depths and gaps for real materials. Back to the GATE Physics course.

Check yourself

1The magnetic flux through a superconducting ring is quantised in units of
2A superconductor is type II when κ = λ/ξ is
3In weak-coupling BCS theory, 2Δ(0) equals

Sources

  • M. Tinkham, Introduction to Superconductivity, 2nd ed. (1996), chapters 1 to 4 and 6
  • C. Kittel, Introduction to Solid State Physics, 8th ed. (2005), chapter 10
  • J. F. Annett, Superconductivity, Superfluids and Condensates (2004), chapters 2 to 6
  • GATE Physics (PH) syllabus, solid state physics section, published by the organising institute each year

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Not affiliated with the IITs, IISc or the GATE organising institute. The general aptitude part of GATE is not covered here. Check the official GATE website for the current pattern. All questions are original.