Module 5: Thermodynamics and statistical physics · Lesson 5.6 · about 45 min
The Fermi gas
The ideal Fermi gas from T = 0 upwards: the Fermi sphere, Fermi energy, temperature and velocity, ground-state energy and degeneracy pressure, the Sommerfeld expansion for the chemical potential and heat capacity, Pauli paramagnetism, the 2D electron gas, liquid helium-3, white dwarfs and neutron stars.
Module 5 · about 45 minutes. By the end you will be able to compute , , and for any Fermi system, find its energy, pressure and bulk modulus at , use the Sommerfeld results for , and , explain Pauli paramagnetism, and estimate the physics of white dwarfs and neutron stars. You need the Fermi-Dirac occupation from lesson 5.4.
1. The Fermi sphere
At the lowest single-particle states are full. In -space they fill a sphere of radius ; with spin states per :
- kF
- Fermi wavevector, about 3.1/(spacing between particles); depends on n only
- EF, TF = EF/k, vF = ħkF/m
- for copper (n = 8.47×10²⁸ m⁻³): 7.0 eV, 8.2×10⁴ K, 1.6×10⁶ m/s
- g(EF) = 3N/2EF
- density of states at the Fermi level: it controls heat capacity, spin susceptibility and screening
- Physical meaning
- T ≪ TF means degenerate: metals at room temperature (T/TF ≈ 0.004), liquid ³He below 1 K (TF ≈ 5 K), white dwarfs (TF ~ 10⁹ K) and neutron stars (EF ≈ 60 MeV).
Worked example. Sodium, m⁻³: m⁻¹, eV, K. Note the scalings ; spinless fermions at the same density would have larger by . In 2D, and , linear in density.
2. Energy, pressure and stiffness at T = 0
With filled to :
because . For copper Pa, held in by the ions; for sodium the electron-gas bulk modulus is 9.2 GPa against the measured 6.3 GPa, so alkali metals are soft because their electron gas is. The mean speed at is and the entropy is zero.
3. Finite temperature: the Sommerfeld expansion
Heating smears the step over a few . Integrals of the form can be expanded in because is a narrow peak at :
The chemical potential falls because increases with energy: smearing would otherwise put more electrons above than it takes from below. (In 1D, where falls, rises; in 2D, with constant , there is no term at all.) The heat capacity is linear in and tiny: about electrons gain about each.
Worked example (γT + βT³). A metal at low temperature has . Plot against : the intercept is , the slope . For copper ( mJ mol⁻¹ K⁻², K) the two terms are equal at K. Interactions renormalise , which is how heavy-fermion metals reveal effective masses of hundreds of electron masses.
4. Pauli paramagnetism
A field shifts the spin-up and spin-down bands by . Only electrons within of can flip, so
nearly independent of temperature, unlike Curie’s . For sodium . (Orbital motion adds Landau diamagnetism, for free electrons.)
5. Degenerate stars
- White dwarfs. About a solar mass in the volume of the Earth; electron density m⁻³, so MeV, comparable to . Non-relativistic degeneracy pressure balances gravity and gives : heavier white dwarfs are smaller.
- Relativistic limit. For , and , the same scaling as gravity. The balance then fixes the mass: the Chandrasekhar limit, about .
- Neutron stars. At nuclear density fm⁻³ the neutron MeV (non-relativistic estimate), far above MeV: cold degenerate matter, supported by neutron degeneracy plus the nuclear repulsion.
Electrons, not nuclei, hold up a white dwarf because at equal density : the electron gas pushes 1839 times harder than a neutron gas would.
“At absolute zero the electrons in a metal are at rest.” At the electrons at the Fermi surface move at about m/s, and the average kinetic energy is several eV, far more than the thermal eV at room temperature. Pauli exclusion, not heat, sets their motion; temperature only ruffles the surface of the Fermi sea.
- , , ; 2D: .
- : , , , , .
- Sommerfeld: , ; metals: .
- Pauli , temperature independent.
- Relativistic: ; white dwarfs up to the Chandrasekhar mass.
Practise: exam questions on this lesson
They start easy and climb to top-rank level. Check each answer, then read the full solution. More on the GATE practice page.
Next: lesson 5.7, phase transitions. For electrons in semiconductors, where the Fermi level sits in a gap, see the JAM lesson on semiconductors, and plot Fermi-Dirac curves with fibub’s quantum statistics plotter.
Check yourself
Sources
- R. K. Pathria and P. D. Beale, Statistical Mechanics, 4th ed. (Academic Press, 2021), chapter 8
- N. W. Ashcroft and N. D. Mermin, Solid State Physics (Saunders, 1976), chapter 2
- C. Kittel and H. Kroemer, Thermal Physics, 2nd ed. (W. H. Freeman, 1980), chapter 7
- K. Huang, Statistical Mechanics, 2nd ed. (Wiley, 1987), chapter 11
- GATE Physics (PH) syllabus, Statistical Physics section, published by the organising institute each year
Your ticks stay in this browser. Save them as a file on the course home.
Updated 2026-11-22. Not affiliated with the IITs, IISc or the GATE organising institute. The general aptitude part of GATE is not covered here. Check the official GATE website for the current pattern. All questions are original.