Module 20: Moving charges and magnetic fields · Lesson 20.1 · about 34 min
Moving charges and magnetic fields
The magnetic force on a moving charge, circular and helical paths, crossed fields, the cyclotron, the Biot-Savart law for wires, arcs and loops, Ampère's law for wires, solenoids and toroids, forces on currents and between wires, torque on a loop and the moving coil galvanometer.
Physics · Class 12 · about 34 minutes. By the end you will be able to predict the path of a charge in a magnetic field, find the field of wires, loops and coils, and work out forces and torques on currents.
1. The magnetic force on a moving charge
The force is perpendicular to both v and B (right-hand rule; reverse it for negative charges). It is zero for a charge at rest or moving along B. With an electric field too, the Lorentz force is .
- B
- magnetic field (tesla, T); 1 T = 1 N/(A m); 1 gauss = 10⁻⁴ T
- θ
- angle between the velocity and the field
- μ₀
- permeability of free space, 4π × 10⁻⁷ T m/A
- Physical meaning
- The force bends the path but never changes the speed, so the kinetic energy of a charge in a pure magnetic field stays constant.
2. Circles, helices and the cyclotron
A charge moving at right angles to a uniform B goes round a circle, with the magnetic force as the centripetal force:
Compare particles accelerated through the same voltage below.
If v makes an angle θ with B, split it: makes the circle (radius ), carries it along B. The path is a helix with pitch .
Crossed fields. With E perpendicular to B, a charge with goes straight through, whatever its charge: a velocity selector. A mass spectrometer follows it with a pure B, where r ∝ m sorts the masses.
Cyclotron. Two D-shaped boxes in a field B, with an AC voltage across the gap at the cyclotron frequency qB/(2πm). The particle gains energy each half-turn in the gap, its radius grows, and it leaves at the rim radius R with . It cannot speed electrons much, because their mass grows with speed (relativity) and they fall out of step.
3. Biot-Savart law: fields of currents
A small piece dl of a wire with current I makes a field , circling the wire. Adding up the pieces gives:
| Current | Field |
|---|---|
| Long straight wire, distance d | |
| Finite wire, angles φ₁, φ₂ from the perpendicular | |
| Centre of a circular loop, N turns | |
| Arc of angle θ (radians), at its centre | |
| Axis of a loop, distance x |
The straight-wire field lines are circles round the wire (curl your right hand’s fingers with the thumb along I). Far along its axis, a loop’s field falls as 1/x³: a loop is a magnetic dipole of moment m = NIA.
4. Ampère’s law: solenoids and toroids
Like Gauss’s law, it gives B quickly when there is symmetry. Inside a long thick wire of radius R, (rising with r), and outside . Inside a long solenoid with n turns per metre, , uniform, and nearly zero outside; at its ends, half that. Inside a toroid of N turns, , and zero outside and in the hole.
“The field inside a solenoid depends on its radius.” For a long solenoid it does not: B = μ₀nI depends only on turns per metre and current. A fat and a thin solenoid with the same n and I have the same field inside.
5. Forces on currents
A straight wire of length L in a field: . A curved wire between two points in a uniform field feels the same force as a straight wire joining those points; a closed loop in a uniform field feels zero net force.
Two parallel wires a distance d apart: , attracting for currents in the same direction. The ampere was once defined from this: 2 × 10⁻⁷ N/m between 1 A wires 1 m apart.
6. Torque on a loop and the galvanometer
A loop of N turns, area A and current I in a uniform field B feels a torque , where θ is the angle between the loop’s normal and B. Its energy is , lowest when m lines up with B.
A moving coil galvanometer uses a radial field (so θ = 90° always) and a spring of torsion constant k: , so the deflection φ is proportional to I. Current sensitivity φ/I = NAB/k; voltage sensitivity φ/V = NAB/(kG). Doubling N doubles the current sensitivity but also doubles G, so the voltage sensitivity stays the same.
Worked example (level 4). An electron moving at 2 × 10⁶ m/s enters a 1 mT field at 60° to it. Radius mm. Period s. Pitch = (2 × 10⁶ × cos 60°) × 3.6 × 10⁻⁸ ≈ 3.6 cm.
- F = qv × B: perpendicular to v, no work, speed constant; zero along B.
- r = mv/qB = √(2mK)/qB; T = 2πm/qB, independent of speed. Helix pitch 2πmv cos θ/qB.
- Velocity selector v = E/B; cyclotron K_max = q²B²R²/2m.
- Straight wire μ₀I/2πd; loop centre μ₀NI/2R; arc μ₀Iθ/4πR; axis μ₀IR²/2(R² + x²)^{3/2}.
- Solenoid μ₀nI inside; toroid μ₀NI/2πr; thick wire μ₀Ir/2πR² inside.
- F = IL × B; closed loop in uniform B: no net force. Parallel wires μ₀I₁I₂/2πd, like currents attract.
- τ = NIAB sin θ; galvanometer NIAB = kφ; shunt and series resistor convert it to meters.
Check yourself
Sources
- National Medical Commission NEET (UG) syllabus and JEE Main / JEE Advanced 2026 syllabi: Magnetic effects of current
- Vacuum magnetic permeability μ₀ = 1.256 637 061 27 × 10⁻⁶ N/A² (about 4π × 10⁻⁷), CODATA 2022 via NIST https://physics.nist.gov/cuu/Constants/
Your ticks stay in this browser. Save them as a file on the course home.
Updated 2026-11-22. Syllabus and exam pattern follow the official NMC and NTA notices checked on 2026-11-22; they can change every year, so check neet.nta.nic.in. All questions are original fibub work, not copied from past papers or books. Nothing you do here is sent anywhere.