All lessons

Module 6: Work, energy and power · Lesson 6.2 · about 28 min

Work, energy and power: question types and traps

Every way entrance exams ask about work and energy: sign of work, area under F-x, the work-energy theorem with friction, springs, conservative forces, potential energy curves, power at constant speed and constant power, and the vertical circle, each with a method and its trap.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Physics · Class 11 · about 28 minutes. Read the lesson Work, energy and power first. Here you meet every question type, with a worked example and the trap, then practise.

Energy methods skip the middle of a motion. Fix two moments, list every energy at each, account for the work of friction and of any outside force, and the speed or distance falls out in one line.

The ten question types

1. Sign and size of work. W = Fs cos θ. Trap: the normal force and a string in uniform circular motion do zero work; friction on a block placed on a moving belt does positive work on the block.
2. Variable force. Integrate F dx or find the area under F-x. Trap: multiplying the final force by the distance.
3. Work-energy theorem. Sum of all work = ΔK. Good when friction acts over a known distance.
4. K and p. K = p²/2m. "p up by 10%": K up by 21%. "K up by 300%": p doubles. Trap: treating percentages as linear.
5. Springs. ½kx²; cut a spring in half and k doubles; series and parallel springs. Trap: energy from x₁ to x₂ is ½k(x₂² − x₁²), not ½k(x₂ − x₁)².
6. Conservative forces. Path independence, F = −dU/dx, work round a loop. Trap: gravity's work depends only on the change in height, not on the path.
7. Potential energy curves. Equilibrium where dU/dx = 0; stable where d²U/dx² > 0; turning points where E = U.
8. Power. P = Fv; steady speed means driving force = resistance; pumps and lifts with efficiency. Trap: forgetting the kinetic energy given to the water.
9. Vertical circle and hemisphere. Energy for speed, F = mv²/r for tension or normal force; leaving the surface means N = 0.
10. Chains and ropes. Lifting a hanging chain: use the rise of its centre of mass. Trap: a hanging part of length L/n rises only L/(2n) on average.

Worked examples

Example 1 (level 3, chain). A uniform chain of mass 2 kg and length 1.2 m lies on a smooth table with one-third of it hanging over the edge. How much work pulls it all back on the table? (g = 10 m/s²)

Solution. The hanging part has mass 2/3 kg and its centre is 0.2 m below the edge. Work = mgh = (2/3) × 10 × 0.2 = 1.33 J. Trap: using the whole mass or the full 0.4 m.

Example 2 (level 4, spring and friction). A 1 kg block moving at 4 m/s on a floor with μ = 0.2 hits a spring of k = 100 N/m. Find the greatest compression. (g = 10 m/s²)

Solution. Energy: 12(1)(16)=12(100)x2+0.2×10×x, so 50x2+2x−8=0. x=−2+4+1600100 = 0.38 m. Without friction it would be 0.4 m.

Example 3 (level 4, potential energy curve). A particle has U(x)=x3−6x2+9x (joules, metres). Find the points of equilibrium and their type.

Solution. dU/dx=3x2−12x+9=3(x−1)(x−3), zero at x = 1 and x = 3. d2U/dx2=6x−12: at x = 1 it is −6 (a hill, unstable), at x = 3 it is +6 (a valley, stable).

Example 4 (level 5, constant power). A car of mass m starts from rest with constant power P. Find its speed after time t and the distance in that time, ignoring resistance.

Solution. All the work goes into kinetic energy: Pt=12mv2, so v=2Pt/m, which grows as √t. Then x=∫vdt=232P/mt3/2. So distance grows as t^(3/2): doubling the time gives 2.83 times the distance.

“The work done by friction is always negative.” Friction from a moving belt or a truck floor does positive work on a box it carries forward. Only the total work of a friction pair between two sliding surfaces is always negative (it makes heat).

Two-moment method
K₁ + U₁ + work of outside forces = K₂ + U₂ + heat from friction
Percent changes
K ∝ p²: a small change of x% in p changes K by about 2x%
Physical meaning
Energy bookkeeping avoids forces that do no work (normal forces, strings in circles), which is why it is often shorter than F = ma.

Practise

The set climbs from level 1 to level 5 and includes numericals, assertion-reason, statements, matching lists, multi-correct and passage questions. Templates give new numbers each time.

  • Ten types: sign of work, variable force, work-energy theorem, K and p, springs, conservative forces, U curves, power, vertical circle, chains.
  • Area under F-x for a varying force; ½k(x₂² − x₁²) for springs.
  • Friction heat = μN × distance slid; it enters the energy equation as a loss.
  • U curve: dU/dx = 0 for equilibrium; the sign of d²U/dx² tells stable or unstable.
  • Constant power from rest: v ∝ √t, x ∝ t^(3/2).

Check yourself

1A force F = 3x² N acts on a body along x. The work done from x = 0 to x = 2 m is:
2A spring is stretched 2 cm, which needs 4 J. Stretching it a further 2 cm needs:
3A car's engine gives constant power. As it speeds up on a level road, its acceleration:

Sources

  • JEE Main, JEE Advanced 2026 and NEET (UG) syllabi: Work, energy and power; question patterns studied from the exams' published papers (no questions copied)

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Syllabus and exam pattern follow the official NMC and NTA notices checked on 2026-11-22; they can change every year, so check neet.nta.nic.in. All questions are original fibub work, not copied from past papers or books. Nothing you do here is sent anywhere.