Module 22: Electromagnetic induction · Lesson 22.2 · about 28 min
Electromagnetic induction: question types and traps
Every way entrance exams ask about induction: flux and its graphs, direction by Lenz's law, induced charge, sliding, rotating and inclined rods, rails with resistors, capacitors and inductors, loops entering fields, induced electric fields, inductance, LR circuits and generators, each with a method and its trap.
Physics · Class 12 · about 28 minutes. Read the lesson Electromagnetic induction first. Here you meet every question type, with the method and the trap, then practise.
The ten question types
Worked examples
Example 1 (level 3, semicircular rod). A wire bent into a semicircle of radius r moves at v perpendicular to its diameter, in a field B perpendicular to its plane. Find the emf between its ends.
Solution. A curved conductor in a uniform field gives the same emf as the straight line between its ends, which has length 2r and moves at right angles to itself: ε = 2Brv. If it moved along its diameter, the emf would be zero.
Example 2 (level 4, rails with a capacitor). A rod of mass m on smooth rails l apart, joined by a capacitor C, in field B, is pulled by a constant force F. Find its acceleration.
Solution. Capacitor charge q = CBlv, so current . Backward force BIl = CB²l²a. Newton: F − CB²l²a = ma, so a = F/(m + CB²l²): constant, the rod never reaches a terminal speed. The capacitor acts like extra mass.
Example 3 (level 4, loop falling out of a field). A square loop of side l, mass m, resistance R, falls under gravity, its lower edge already out of a horizontal field region, its top edge still inside. If it falls at a steady speed while leaving, find that speed.
Solution. Only the top edge cuts field lines: emf Blv, current Blv/R, upward force B²l²v/R. Steady when B²l²v/R = mg: v = mgR/(B²l²). The loss of potential energy goes entirely into heat.
Example 4 (level 5, LR with a parallel resistor). A battery E with a switch feeds R₁ in series with a parallel pair: an inductor L and a resistor R₂. Find the battery current just after the switch closes, and long after.
Solution. At t = 0 the inductor carries no current: the circuit is R₁ + R₂, so I₀ = E/(R₁ + R₂). Long after, the inductor is a wire shorting R₂: I∞ = E/R₁. The time constant uses the resistance seen by the inductor with the battery shorted: R₁ ∥ R₂, so .
“No current flows, so no emf is induced.” An emf appears whenever the flux changes, even in an open loop or a single rod. The current needs a closed circuit; the emf does not.
- Rail rules
- with R: terminal speed; with C: constant acceleration; with L only: SHM
- Curved conductor
- same emf as the straight chord joining its ends
- Physical meaning
- Lenz's law is energy conservation in disguise: if the induced current helped the change, a small push would run away into endless energy.
Practise
The set climbs from level 1 to level 5 and includes numericals, assertion-reason, statements, matching lists, multi-correct and passage questions. Templates give new numbers each time.
- Ten types: graphs, direction, induced charge, rods, rotation, rails, loops in fields, induced E, inductance, LR and generators.
- emf is the slope of the flux graph; flux is the area under the emf graph.
- Curved rod = straight chord; rotating rod ½Bωl².
- Rails with C: a = F/(m + CB²l²); with R: v_t = FR/(B²l²).
- Inductor: open circuit at t = 0, wire at t = ∞; τ uses the resistance seen by L.
- Generator emf largest when the coil’s plane is along B.
Check yourself
Sources
- JEE Main, JEE Advanced 2026 and NEET (UG) syllabi: Electromagnetic induction; question patterns studied from the exams' published papers (no questions copied)
Your ticks stay in this browser. Save them as a file on the course home.
Updated 2026-11-22. Syllabus and exam patterns follow the official notices checked on 2026-11-22; they can change every year, so check the official exam website. All questions are original fibub work, not copied from past papers or books. Nothing you do here is sent anywhere.