All lessons

Module 59: Trigonometric functions and identities · Lesson 59.1 · about 36 min

Trigonometric functions and identities

Radian measure, the six ratios on the unit circle, signs by quadrant, allied angles, graphs and periods, compound, multiple and half angles, sum-to-product formulae, identities in a triangle, greatest and least values, and the product and series tricks JEE Advanced uses.

Key points, meanings and formulas on one page: choose "Save as PDF" in the print box.

Maths · Class 11 · about 36 minutes. By the end you will be able to move between degrees and radians, find any ratio of any angle without a table, draw and read the graphs of the six functions, use the compound, multiple and sum-to-product formulae fluently, and find greatest and least values, which is where most JEE trigonometry marks are won.

Trigonometry is the geometry of a point going round a circle of radius 1. Its x-coordinate is cos θ and its y-coordinate is sin θ. Every sign rule, every allied-angle formula and every period comes from watching that point move.

1. Measuring angles: radians

One radian is the angle at the centre of a circle when the arc is as long as the radius. A full turn holds 2π radians, so

π rad=180∘,1 rad≈57.3∘,s=rθ(θ in radians)

Radians are not just another unit. They make the arc formula s=rθ and the area of a sector 12r2θ work with no extra factors, and calculus needs them (the limit sin⁡x/x→1 is true only in radians).

2. The six functions on the unit circle

Put a point P on the circle x2+y2=1, at angle θ measured anticlockwise from the positive x-axis. Then

cos⁡θ=x,sin⁡θ=y,tan⁡θ=yx,sec⁡θ=1x,cosec⁡θ=1y,cot⁡θ=xy

Since P is on the circle, sin2⁡θ+cos2⁡θ=1. Dividing by cos2⁡θ and by sin2⁡θ gives 1+tan2⁡θ=sec2⁡θ and 1+cot2⁡θ=cosec2⁡θ.

P goes round the unit circle. Its height is sin θ, its horizontal position is cos θ, and the point where OP meets the line x = 1 gives tan θ. On the right the angle is unrolled into the graphs.
θ
the angle, measured anticlockwise from the positive x-axis (clockwise angles are negative)
sin θ, cos θ
the y and x coordinates of P on the circle of radius 1, so both stay between −1 and 1
tan θ
the slope of OP; it is not defined when OP is vertical (θ = 90°, 270°)
Reference angle
the acute angle OP makes with the x-axis; it fixes the size of every ratio
Physical meaning
Two angles with the same reference angle give ratios of the same size. Only the quadrant decides the sign.

Signs by quadrant. In quadrant I all ratios are positive; in II only sin (and cosec); in III only tan (and cot); in IV only cos (and sec). Drag the slider in the figure and watch the coloured bars flip.

Allied angles. For angles like 90° ± θ, 180° ± θ, 270° ± θ, 360° − θ: write the sign the original function has in that quadrant (treat θ as small and acute), then keep the function name for 180° and 360°, and switch it to its co-function (sin ↔ cos, tan ↔ cot, sec ↔ cosec) for 90° and 270°. So sin⁡(180∘+θ)=−sin⁡θ and cos⁡(270∘−θ)=−sin⁡θ.

“sin 2θ is twice sin θ.” No. The function is not a multiplier: sin 60° = 0.866, but 2 sin 30° = 1. The correct rule is sin 2θ = 2 sin θ cos θ.

3. Graphs, ranges and periods

Function Range Period Not defined at
sin x, cos x [−1, 1] 2π nowhere
tan x, cot x all reals π tan: odd multiples of π/2; cot: multiples of π
sec x, cosec x (−∞, −1] ∪ [1, ∞) 2π where cos or sin is zero

Rules for periods: sin(kx) has period 2π/|k|. |sin x| and sin²x have period π, because the negative half becomes a copy of the positive half. The period of a sum is the LCM of the periods, but check for a smaller one: |sin x| + |cos x| has period π/2, not π.

4. Compound angles

sin⁡(A±B)=sin⁡Acos⁡B±cos⁡Asin⁡B,cos⁡(A±B)=cos⁡Acos⁡B∓sin⁡Asin⁡B
tan⁡(A±B)=tan⁡A±tan⁡B1∓tan⁡Atan⁡B

Two handy results: sin⁡(A+B)sin⁡(A−B)=sin2⁡A−sin2⁡B and cos⁡(A+B)cos⁡(A−B)=cos2⁡A−sin2⁡B. From these come exact values such as sin⁡15∘=6−24 and tan⁡75∘=2+3.

5. Multiple and half angles

sin⁡2A=2sin⁡Acos⁡A=2tan⁡A1+tan2⁡A,cos⁡2A=cos2⁡A−sin2⁡A=1−2sin2⁡A=2cos2⁡A−1
sin⁡3A=3sin⁡A−4sin3⁡A,cos⁡3A=4cos3⁡A−3cos⁡A,tan⁡3A=3tan⁡A−tan3⁡A1−3tan2⁡A

Read 1−cos⁡2A=2sin2⁡A and 1+cos⁡2A=2cos2⁡A backwards whenever you see 1 ± cos: they turn a sum into a square. Also sin⁡18∘=5−14 and cos⁡36∘=5+14, which come from 2θ = 90° − 3θ with θ = 18°.

6. Sum to product and back

sin⁡C+sin⁡D=2sin⁡C+D2cos⁡C−D2,cos⁡C+cos⁡D=2cos⁡C+D2cos⁡C−D2
sin⁡C−sin⁡D=2cos⁡C+D2sin⁡C−D2,cos⁡C−cos⁡D=−2sin⁡C+D2sin⁡C−D2

Going the other way, 2sin⁡Acos⁡B=sin⁡(A+B)+sin⁡(A−B) and 2sin⁡Asin⁡B=cos⁡(A−B)−cos⁡(A+B). Use sum-to-product to factor an equation; use product-to-sum to add up a series.

Worked example. Show that cos⁡20∘cos⁡40∘cos⁡80∘=18. Multiply and divide by 2sin⁡20∘ and use 2sin⁡Acos⁡A=sin⁡2A three times: the top becomes sin⁡160∘/4=sin⁡20∘/4 over 2sin⁡20∘, which is 1/8. In general

cos⁡Acos⁡2Acos⁡4A⋯cos⁡2n−1A=sin⁡2nA2nsin⁡A

7. Identities in a triangle (conditional identities)

When A + B + C = π, each angle is π minus the other two, so sin⁡(A+B)=sin⁡C, cos⁡(A+B)=−cos⁡C, and

tan⁡A+tan⁡B+tan⁡C=tan⁡Atan⁡Btan⁡C,sin⁡2A+sin⁡2B+sin⁡2C=4sin⁡Asin⁡Bsin⁡C

Prove such identities by changing the first two terms with sum-to-product, then replacing A + B by π − C.

8. Greatest and least values (JEE favourite)

  • asin⁡x+bcos⁡x lies between −a2+b2 and a2+b2, because it equals a2+b2sin⁡(x+α).
  • For expressions in one ratio, substitute t = sin x (with −1 ≤ t ≤ 1) and find the range of the resulting quadratic on that interval, not on all reals.
  • a2sec2⁡x+b2cosec2⁡x≥(a+b)2 and tan2⁡x+cot2⁡x≥2 follow from AM ≥ GM.
  • In a triangle, products like cos A cos B cos C are largest (1/8) when the triangle is equilateral.

“sin²x + sin x has least value 0, because squares are never negative.” With t = sin x, t² + t = (t + 1/2)² − 1/4, and t = −1/2 is allowed, so the least value is −1/4. Always find the vertex and check it lies in [−1, 1].

Series in AP angles. For angles in arithmetic progression,

∑k=0n−1sin⁡(α+kβ)=sin⁡nβ2sin⁡β2sin⁡(α+(n−1)β2)

and the same with cos on both sides. It comes from multiplying by 2sin⁡β2 and letting product-to-sum telescope.

  • π rad = 180°; s = rθ and the sector area ½r²θ need θ in radians.
  • cos θ and sin θ are the coordinates of a point on the unit circle; sin²θ + cos²θ = 1.
  • Signs: all, sin, tan, cos in quadrants I to IV. Allied angles keep the name at 180° and 360°, switch to the co-function at 90° and 270°.
  • sin kx has period 2π/|k|; |sin x| and sin²x have period π.
  • Learn the compound, double, triple and sum-to-product formulae both ways.
  • a sin x + b cos x ranges over [−√(a² + b²), √(a² + b²)]; for one-ratio expressions, keep the variable inside [−1, 1].
  • Products cos A cos 2A … cos 2ⁿ⁻¹A: multiply by 2 sin A and fold.

Check yourself

1What is the value of cos 240°?
2The smallest positive period of sin 3x is:
3The greatest value of 5 sin x − 12 cos x is:

Sources

  • NCERT Mathematics Class 11 (Trigonometric functions): topics followed, no text copied
  • JEE Main and JEE Advanced 2026 syllabi: Trigonometry

Your ticks stay in this browser. Save them as a file on the course home.

Updated 2026-11-22. Syllabus and exam patterns follow the official notices checked on 2026-11-22; they can change every year, so check the official exam website. All questions are original fibub work, not copied from past papers or books. Nothing you do here is sent anywhere.